Joined: 18 Mar 2014 Posts: 12917 Location: Netherlands
Posted: Tue Oct 24, 2023 8:51 Post subject: New Build - 10/24/2023 - r53763
On behalf of @blkt:
Welcome to Marvell r53763 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp) 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Debug Analyze: stracetcpdump.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Router Model Linksys WRT1900ACS v2
Firmware Version DD-WRT v3.0-r53763 std (10/24/23)
Kernel Version Linux 6.1.59 #60 SMP Tue Oct 24 07:06:32 +07 2023 arm
Current Time Tue, 24 Oct 2023 12:05:51
Uptime 8 min
update-browser waterfox, I switched from r53734 with keeping the settings, all ok
connection Type PPPoE - IPv6 Type DHCPv6 with Prefix Delegation 1Gbps
IPv6 Type DHCPv6 with Prefix Delegation-On - all Ok
Operating Mode Gateway/AP
Shortcut Forwarding Engine-On
Schedule Reboot-On,
Web Access Protocol - HTTPS,
SSH (public key)-all ok
Encrypt DNS Enable
Validate DNS Replies (DNSSEC)-all ok
Port Forwarding - all Ok,
USB - System Log -all Ok
Schedule Reboot - At a Set Time - On
Wireless Interface 2.4GHz-Wireless Mode AP-Wireless Network Mode-N, Width VHT 40 Mhz-Wireless Channel-11, Extension Channel Lower,RTS Threshold 2346, Short Preamble, Short GI, Radio Scheduling,TX Power-30dBm ,TX Antenna Chains-1+2+3+4, RX Antenna Chains1+2+3+4, Enable-WPA2 - WPA3 Personal / SAE-CCMP-128 (AES) all-ok!
the installation went quickly without any problems
Personally, with each updated version, I will try to publish the system logs a day after installation, please check if you want real-time information about how the respective version works!
_________________ Internet provider https://en.wikipedia.org/wiki/RCS_%26_RDS 1Gbps
WDR3600 rev.1.5 - DD-Wrt
Linksys WRT1900ACS v.2 DD-Wrt/-OpenWrt
I will publish now the system logs after installation _________________ Internet provider https://en.wikipedia.org/wiki/RCS_%26_RDS 1Gbps
WDR3600 rev.1.5 - DD-Wrt
Linksys WRT1900ACS v.2 DD-Wrt/-OpenWrt
@oliver44 are you really getting 1 GB/s LAN <> WAN throughput on this new kernel 6.1?
yes, of course, but the network card in the computer sometimes gives me problems, I have to reconnect once in a while!
I think it's the network card in the PC, you see something else in the logs, because I reconnect to the network card in the PC, it must be the port in the router with problems, but it does this to all the ports in the router if I connect it, where do you say the problem is? _________________ Internet provider https://en.wikipedia.org/wiki/RCS_%26_RDS 1Gbps
WDR3600 rev.1.5 - DD-Wrt
Linksys WRT1900ACS v.2 DD-Wrt/-OpenWrt
I noticed the only anomaly, immediately after the router is turned on with ddwrt, you get a maximum of 940Mbps in the speed test, then it drops to 929, a minimum of 920 MBps dowlowd upload, but I think I have a problem with the network card in the PC, sometimes it gets on the link 100 even if it is set to auto or duplex 1000!
Now I don't know what's with that drop down from 1000 to 100Mbps, but not all the time
I also noticed this problem on openwrt and ddwrt _________________ Internet provider https://en.wikipedia.org/wiki/RCS_%26_RDS 1Gbps
WDR3600 rev.1.5 - DD-Wrt
Linksys WRT1900ACS v.2 DD-Wrt/-OpenWrt
Joined: 08 May 2018 Posts: 14249 Location: Texas, USA
Posted: Tue Oct 24, 2023 10:39 Post subject:
Router: WRT3200ACM
Version: DD-WRT v3.0-r53763 std (10/24/23)
File: ddwrt-linksys-wrt3200acm-webflash.bin
Kernel: Linux 6.1.59 #60 SMP Tue Oct 24 07:06:32 +07 2023 arm
Previous: DD-WRT v3.0-r53734 std (10/23/23)
Reset: No
Mode: Gateway, wlan0 AP, wlan1 & wlan2 disabled.
Status: Ok
Uptime: ~9 hours
Issues/Errors: None to report at present, still some re-configuration required for testing recent issues reported by others. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
