Posted: Thu Oct 13, 2022 5:21 Post subject: New Build - 10/13/2022 - r50500
Welcome to x86 / x64 r50500 beta release thread for reporting, feedback to developers & community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Joined: 27 Oct 2009 Posts: 70 Location: Woodstock,Ontario
Posted: Mon Oct 17, 2022 13:28 Post subject: this build
2nd gen intel board dq67sw and i5 2400 I can't seem to access the webserver it just says "refuse connection". Is there a command I can send through telnet to turn it on ?
Joined: 18 Mar 2014 Posts: 12922 Location: Netherlands
Posted: Mon Oct 17, 2022 13:51 Post subject: Re: this build
32dave wrote:
2nd gen intel board dq67sw and i5 2400 I can't seem to access the webserver it just says "refuse connection". Is there a command I can send through telnet to turn it on ?
Joined: 27 Oct 2009 Posts: 70 Location: Woodstock,Ontario
Posted: Mon Oct 17, 2022 14:22 Post subject:
the-joker wrote:
See if this is http vs https browser side issue.
I just flashed last version image over this version, and it saved all my settings and now have web server but once I change the settings I can update and see