[soulkoden]

I have a WiFi network and I need to have two WiFi networks:
1. Non VPN
2. With VPN

First router is Huawei 5573 shared internet connection .
Second router is TP Link DIR-300 Rev B with DD-WRT firmware on the board.

I need to connect from TP Link to Huawei via WiFi. After that connect to VPN server (L2TP, OpenVPN, no matter) through internet. After share private network through WiFi on the TP Link.

I have read a lot of manuals but don't understand

On the some manuals I see screenshots with Client mode compatible with Virtual Network section, but if I choose Client mode that section do not visible.

Direct repeater mode is works but it's not what I need.

[egc]

If you have repeater mode you can use that to setup a connection to your huawei.
You have a separate subnet, you can setup an OVPN client on the D-link and all traffic from the D-link is going through the VPN.

If you do not want that you can use Policy Based Routing to single out IP addresses of clients which you want to use the VPN all else uses the normal WAN.

BTW, not sure if this low end hardware has OpenVPN in the builds.

[soulkoden]