Posted: Sat Jan 13, 2024 20:32 Post subject: 2 Linksys wrt3200acm 1 26tx 2 30tx
Hello
I have 2 Linksys wrt3200acm routers, one with max 26tx and 2 with 30tx in the same settings.It's the same firmware, I don't know why. Maybe someone knows what's going on. Previous firmware versions were exactly the same. I would like both to have the same power. Both are set to USA. Thank you
What DD-WRT firmware version is currently flashed? _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio
The information is probably hard-coded in the wireless hardware, but the only way to be sure is to do a full reset after upgrading to current release (54905 as of this post). Keep in mind, do not select "reset to defaults" under "After flashing". The reset has to be done after the router reboots. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio
I have had this 26tx router for a long time and it was like this all the time. I bought the 30tx one and dd wrt was already originally installed there. This is the router originally purchased from the flash router website. How can I increase the power in my old one and why is it that one has 26 and the other 30?
I know what you mean, but when two routers are placed next to each other, one has a longer range than the other. of course I checked one by one. And I had both of them set to the US (identical settings).
I will write again, the settings are the same, identical, all settings are cloned
how to set them so that they are the same and have the same transmitting power
And I don't care about your "same settings" - as there is also the "auto channel" setting - in this setting the WLAN channels are selected automatically - and AGAIN different channels have different transmitting powers.
I think I would have to install openwtr if so, I wouldn't want to do that unless I'm wrong. I was going to buy a UART and start learning how to use this device. not necessarily starting with Linksys so as not to break something, but if someone could help me, it would be great.Maybe I'll take these two devices apart first and compare the motherboards