Posted: Thu Jun 22, 2023 6:24 Post subject: New Build - 06/22/2023 - r53045
Welcome to Marvell r53045 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp) 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Router Model Linksys WRT1900ACS v2
Firmware Version DD-WRT v3.0-r53045 std (06/22/23)
Kernel Version Linux 4.9.337 #3889 SMP Thu Jun 22 05:55:14 +07 2023 armv7l
Uptime 3 min
update-browser waterfox, I switched from r53028 without saving the settings
If I keep the settings, the ping is fine!
connection Type PPPoE - IPv6 Type DHCPv6 with Prefix Delegation 1Gbps
IPv6 Type DHCPv6 with Prefix Delegation-On - Ok
Operating Mode Gateway/AP
Shortcut Forwarding Engine-On
Schedule Reboot-On,ok
Web Access Protocol - HTTPS,
SSH (public key)-ok
SmartDNS Resolver ok
Port Forwarding - Ok,
USB - System Log -Ok
Schedule Reboot - At a Set Time - On
Wireless Interface 5GHz-Wireless Mode AP-Wireless Network Mode-AC/N, Width VHT 80 Mhz-Wireless Channel-36,Extension Channel UU, Short GI, Short Preamble, Single User Beamforming, Radio Scheduling, TX Power-30dBm ,TX Antenna Chains-1+2+3+4, RX Antenna Chains-1+2+3+4, Enable-WPA2 Personal-CCMP-128 (AES), Regulatory Domain Romania, all-ok!
Hi All,
I just realized there are buuld threads. Anyways, I had an issue with this build. I posted my experience here. I cannot reset my router.I just wanted to know if it's a known issue and what I can do about it? Should I just update to the newest firmware?
