Posted: Wed Oct 19, 2022 6:09 Post subject: New Build - 10/19/2022 - r50551
Welcome to Atheros r50551 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Netgear Nighthawk X10 R9000
Firmware Version DD-WRT v3.0-r50551 std (10/19/22)
Kernel Version Linux 4.9.330 #651 SMP Tue Oct 4 13:04:30 +07 2022 armv7l
Current Time Wed, 19 Oct 2022 05:34:14
Uptime 2 min
GUI over 50500
Reset: no
Issues: none
Joined: 31 Jul 2021 Posts: 2146 Location: All over YOUR webs
Posted: Wed Oct 19, 2022 21:12 Post subject:
bushant wrote:
Small visual problem I first noticed On Setup->DDNS tab help section on 50516
EDIT: problem is noticed using Chromium on linux. all is well using FFX
Very interrrresting... DDNS page you say? I shall investimatigate though this build 50516 is suspect could it have been built at a point its shouldn't have been.
Any setup you have on this page would help if any.
PS I already found an ancient bug with freedns.afraid.org unrelated to this, just select freedns.afraid.org dont setup anything else click apply, click OK past the alert windows saying there's no username/password and voila the Hostname input is magically populated with "User/Password wrong"
Joined: 05 Oct 2008 Posts: 667 Location: Helsinki, Finland / nr. Alkmaar, Netherlands
Posted: Thu Oct 20, 2022 9:38 Post subject:
upgraded my R7800 using easyddup from the previous version that was removed.
No problems.
Just an observation from the active client list. See screenshot. The cable modem IP is now shown in addition to the WAN Gateway adress (modem in bridge mode behind a 'small businesses' network firewall).
EDIT: The modem IP disappeared after a number of hours(?) leaving only the gateway IP.
Last edited by ArjenR49 on Thu Oct 20, 2022 15:03; edited 1 time in total