Posted: Mon May 17, 2021 10:28 Post subject: D-link dir-320 a2
Good day. Put on dir320 dd-wrt to configure CoovaChilli
However, I ran into my own difficulties:
The wan port does not work, and when it is turned on, either the ip address (0.0.0.0) is not issued to wan or is issued for a couple of seconds after which it starts to issue an address on the lan ports not from the local network but from the wan network, how can this be fixed?
I tried to assign it instead of wan lan1 to assign it according to the article, but it did not work, it just blocked all lan ports
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=278463
Please refer to the forum rules and guidelines and state what build revision you are running and all applicable information. The thread you linked is for Atheros, and if you are running a build older than r46604, then it will not use swconfig, you will need to use the switched ports wiki.
I am not sure if the swconfig support applies to ALL Broadcom routers or not. You can test via cli to see if swconfig command exists on releases r46604 and up.