From DD-WRT Wiki

You are here: Main Page/DD-WRT Docu (EN)/Web Interface

This is an infant wiki! Please help by fixing formatting and adding content!

Introduction

The easiest way to configure your WRT54G with DD-WRT installed is from the web interface. This provides an experience more like configuring a desktop application. :-)

Accessing

• Open a web browser
• In the location bar, enter <Router_IP>
• Hit Enter/Return or click Go
• There is no username to enter
• Enter the password for your router.

By default, <Router_IP> is 192.168.1.1
Default username is left blank however use root (so username and pwd can be saved to browser [or use firefox, cause it doesn't care])
Default password is admin

Simulation

A setup simulation can be found here:

http://www.0711-stuttgart.de/192.168.1.23 .

The example above uses the old alchemy interface. A new interface will be built for the next dd-wrt final release ;)

Troubleshooting

If you forget your router's IP address or Password you can press and hold the reset button on the back of the router for 5-30 seconds. This will reset all settings to their default, including the IP address and password. This will not unflash your router to the default firmware This will not work if Resetbuttond is set to disabled.

Make sure you are on the same subnet as your router. If your router is 192.168.1.1 and your computers ip address is 192.168.2.50 you may not be able to access the interface. Correct your computers ip address or reboot your computer.

You are here: Main Page/DD-WRT Docu (EN)/Web Interface