Linksys WRT54GS v2.0

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 01:14, 1 May 2020 (edit)
Jeremywh7 (Talk | contribs)
(Fix dead links and deprecated info.)
← Previous diff
Current revision (19:17, 1 May 2020) (edit) (undo)
Jeremywh7 (Talk | contribs)
m (Upgrade Flash - forgot to specify upgrade file type)
 
Line 28: Line 28:
==Upgrade Flash== ==Upgrade Flash==
 +#Any ''generic.bin'' '''/broadcom folder''' build will work under 7995392 bytes (7808KB)
 +#*See [[What_is_DD-WRT%3F#K2.4_Build_Features|K2.4 Build Features]] for file type differences. '''Read build threads first!'''
#Go to ''Administration'' -> ''Firmware Upgrade'' to select the file to ''Upgrade'' #Go to ''Administration'' -> ''Firmware Upgrade'' to select the file to ''Upgrade''
-#'''Wait 5 minutes for the router to reboot (power cycle if needed) then '''reset'''+#Wait 5 minutes for the router to reboot (power cycle if needed) then '''reset'''
#Access the GUI to set a password and configure #Access the GUI to set a password and configure
[[Category:Linksys guides]] [[Category:Linksys guides]]

Current revision

Contents

[edit] WRT54GS v2.0 Specs

  • Chipset: BCM4712
  • Ram: 32 MB
  • Flash: 8 MB


[edit] How To Flash

Read the Firmware FAQ and Broadcom forum build threads before upgrading!

  1. Use GUI or TFTP flash with a wired connection. Disable wireless to be safe.
  2. DO NOT 30/30/30 HARD RESET this model as this could brick your router. See the Peacock Announcement Note 1.


[edit] Initial Flash

Download Build 14929 dd-wrt.v24_mini_wrt54gs.bin

  1. Reset by keeping the router powered on and holding the reset button until the lights flash (up to 30sec)
  2. Open 192.168.1.1 in a web browser (if issues are encountered, try another browser)
    • User = (Leave Blank)
    • Password = admin
    • If this does not work, see the above reset info to restore to factory defaults.
  3. Check the firmware version in the top right corner to be 4.71.4, otherwise flash:
  4. Go to Administration -> Factory Defaults -> Restore -> Apply Settings to flash dd-wrt.v24_mini_wrt54gs.bin
    • Wait 5 minutes for the router to reboot
    • If no response, unplug the router for 10 seconds then plug it back in
  5. Access the GUI to set a password


[edit] Upgrade Flash

  1. Any generic.bin /broadcom folder build will work under 7995392 bytes (7808KB)
  2. Go to Administration -> Firmware Upgrade to select the file to Upgrade
  3. Wait 5 minutes for the router to reboot (power cycle if needed) then reset
  4. Access the GUI to set a password and configure