Hard reset or 30/30/30

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 14:23, 25 August 2008 (edit)
Soulstace (Talk | contribs)
m (cool image, makes warning stand out)
← Previous diff
Revision as of 14:27, 25 August 2008 (edit) (undo)
Soulstace (Talk | contribs)

Next diff →
Line 31: Line 31:
All should be in default settings now. All should be in default settings now.
-[[Category: English documentation]]+[[Category: English documentation]][[Category: Basic tutorials]]

Revision as of 14:27, 25 August 2008

Image:Warning.pngDO NOT attempt to reset or power cycle the router while it is still in the process of upgrading! Wait a couple of minutes after upgrade is complete and the router has rebooted itself.

Hard Reset (aka 30/30/30 reset):

  • With the unit powered on, press and hold the reset button on back of unit for 30 seconds
  • Without releasing the reset button, unplug the unit and hold reset for another 30 seconds
  • Plug the unit back in STILL holding the reset button a final 30 seconds.

This will clear out the NVRAM and set the dd-wrt back to default values.

This procedure should be done BEFORE and AFTER every firmware upgrade/downgrade

Do not use configuration restore if you change firmware builds (different svn build numbers)

Erasing NVRAM:

As an alternative method, it is possible to restore DD-WRT to default settings without using the reset button (useful when the reset button is disabled, broken, etc. or if your router just refuses to reset using 30/30/30).

The following requires that DD-WRT already be installed on your router, and Telnet (or SSH) services be enabled and accessible.

Telnet (or SSH) into

Issue commands:

erase nvram

All should be in default settings now.