Linksys WRT54G v2.2

From DD-WRT Wiki

Jump to: navigation, search

Contents


[edit] Hardware Specifications

https://wikidevi.com/wiki/Linksys_WRT54G_v2.2

[edit] Installation

NOTE: For flashing, only connect the device to the computer.

  1. Read the Peacock announcement
  2. Connect the computer via cable to a LAN port of your router. Do NOT use wireless.
  3. Set a static IP on your computer (e.g. 192.168.1.7, subnet mask 255.255.255.0)
  4. Do a hard reset on the router
  5. Open the Linksys webgui at 192.168.1.1: if a Management Mode page open, power cycle again
  6. Leave the username blank and enter "admin" as the password
  7. Go to Administration->Firmware Upgrade and select 14929 dd-wrt.v24_mini_wrt54g.bin
  8. Click Upgrade then when complete, wait FIVE FULL minutes
    • If not successful, clear browser cache and repeat from step 6
  9. Access the dd-wrt GUI at 192.168.1.1, and reset the router again
  10. At this point you can flash a different build, depending on your needs
  11. Reset your computer ethernet connection to auto IP and DNS

[edit] Reverting to OEM

  1. Download and unzip OEM firmware [1]
  2. As above, reset then go to the DD-WRT GUI, enter a username/password
  3. Go to Administration->Firmware Upgrade and select WRT54G_v4.21.1_fw.bin
  4. Click Upgrade then when complete, wait FIVE FULL minutes
  5. Access the Linksys webgui at 192.168.1.1, and reset the router again
  6. Reset your computer ethernet connection to auto IP and DNS