Posted: Mon Jun 04, 2018 19:17 Post subject: Route Config Help - Cascaded Routers
Hi - Please help me with route configuration on DD-WRT
Router A -
- Connected to WAN (Internet)
- IP 10.0.1.1
- DHCP 10.0.1.2 - 10.0.1.200
- Non DDWRT (nofirmware for Netgear R7900)
- Connected to Router A for Internet.
- IP 192.168.1.1
- Web server IP 192.168.1.30
When i am connected to Router A, I cannot reach web server 192.168.1.30 on Router B
I tried adding a route on Router A
- network 192.168.1.0
- GW 10.0.1.1
interface: LAN & WAN
It did not work and i had to reset Router A to get whole house networking working again.
Please help me on adding the route the right way on a dd-wrt. thanks
Could you please help with the right way to add a route on the Router A (dd-wrt) ?
Last time i added 192.168.1.0 GW 10.0.1.1 Interface Lan&Wan
it broke the whole network and i had to reset and start over again.
i had dhcp reservered the IP of the Router B..and i see what mistake i was doing in routes. instead of the WAN IP of B i was using the GW 10.0.1.1...that was causing the whole network to fail...ok i will give that a try.
on the router B (-netgear R7900 - i hope the experts make dd-wrt firmware)
I dont see firewall in the menu, just Port Forwarding/Port Trigger menu. is this where i configure to allow communication from the 10.0.1.x devices ?
so the source will be 10.0.1.0 and ports will 'all' 0r 0-6555 ?
destination will be 192.168.1.0?
thanks in advance.