TP-LINK TL-WR1043ND hw rev. 1.8 and DD-WRT firmware

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Atheros WiSOC based Hardware
Goto page Previous  1, 2, 3, 4, 5, 6, 7  Next
Author Message
ignaciots
DD-WRT Novice


Joined: 01 Nov 2011
Posts: 12

PostPosted: Sat Jun 08, 2013 16:35    Post subject: Reply with quote
Armethyst wrote:
just finished upgrading,
didn't do any 30/30/30 stuff.
just plain webrevert file(was on ddwrt 21223)>upgrade to latest tplink official version-130428>upgrading to dd wrt 21286 (latest-15/04)>configuring as i need (vpn works btw, its awesome) Smile
and transfer rate according to your configurations (TX=1 RX= 1+2+3) = 10mb almost steady. seems alright, lets see how long will it last.

so far i can't say anything bad, its all great and of course if any dev comes accord this post. THANK YOU!


Awesome! I have recently bought a ver 1.10 (SN: 12XXXXXX)
I'm going to test out the same steps

Thanks!!!!
Sponsor
yishay
DD-WRT Novice


Joined: 31 Dec 2007
Posts: 2

PostPosted: Tue Aug 06, 2013 13:34    Post subject: Latest firmware Reply with quote
ignaciots wrote:
Armethyst wrote:
just finished upgrading,
didn't do any 30/30/30 stuff.
just plain webrevert file(was on ddwrt 21223)>upgrade to latest tplink official version-130428>upgrading to dd wrt 21286 (latest-15/04)>configuring as i need (vpn works btw, its awesome) Smile
and transfer rate according to your configurations (TX=1 RX= 1+2+3) = 10mb almost steady. seems alright, lets see how long will it last.

so far i can't say anything bad, its all great and of course if any dev comes accord this post. THANK YOU!


Awesome! I have recently bought a ver 1.10 (SN: 12XXXXXX)
I'm going to test out the same steps

Thanks!!!!


The latest version is 07-24-2013 r22118
yishay
DD-WRT Novice


Joined: 31 Dec 2007
Posts: 2

PostPosted: Tue Aug 06, 2013 13:35    Post subject: Latest firmware Reply with quote
ignaciots wrote:
Armethyst wrote:
just finished upgrading,
didn't do any 30/30/30 stuff.
just plain webrevert file(was on ddwrt 21223)>upgrade to latest tplink official version-130428>upgrading to dd wrt 21286 (latest-15/04)>configuring as i need (vpn works btw, its awesome) Smile
and transfer rate according to your configurations (TX=1 RX= 1+2+3) = 10mb almost steady. seems alright, lets see how long will it last.

so far i can't say anything bad, its all great and of course if any dev comes accord this post. THANK YOU!


Awesome! I have recently bought a ver 1.10 (SN: 12XXXXXX)
I'm going to test out the same steps

Thanks!!!!


The latest version is 07-24-2013 r22118 from ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2013/07-24-2013-r22118/tplink_tl-wr1043nd/
Armethyst
DD-WRT User


Joined: 03 Jun 2011
Posts: 64

PostPosted: Tue Aug 06, 2013 20:20    Post subject: Re: Latest firmware Reply with quote
yishay wrote:
ignaciots wrote:
Armethyst wrote:
just finished upgrading,
didn't do any 30/30/30 stuff.
just plain webrevert file(was on ddwrt 21223)>upgrade to latest tplink official version-130428>upgrading to dd wrt 21286 (latest-15/04)>configuring as i need (vpn works btw, its awesome) Smile
and transfer rate according to your configurations (TX=1 RX= 1+2+3) = 10mb almost steady. seems alright, lets see how long will it last.

so far i can't say anything bad, its all great and of course if any dev comes accord this post. THANK YOU!


Awesome! I have recently bought a ver 1.10 (SN: 12XXXXXX)
I'm going to test out the same steps

Thanks!!!!


The latest version is 07-24-2013 r22118 from ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2013/07-24-2013-r22118/tplink_tl-wr1043nd/

Being a little picky now, are we? Wink
Relax, this is what i tested back then. i haven't used the latest so i assume it'll work just the same as that.

I did hear something about some recent (not sure about July's) Firmwares that had that WAN issue again... better have another firmware ready to revert just in case Cool
cliggity
DD-WRT Novice


Joined: 09 Aug 2013
Posts: 29
Location: MI, USA

PostPosted: Fri Aug 09, 2013 15:18    Post subject: Confirmation Reply with quote
Armethyst wrote:
just finished upgrading,
didn't do any 30/30/30 stuff.
just plain webrevert file(was on ddwrt 21223)>upgrade to latest tplink official version-130428>upgrading to dd wrt 21286 (latest-15/04)>configuring as i need (vpn works btw, its awesome) Smile
and transfer rate according to your configurations (TX=1 RX= 1+2+3) = 10mb almost steady. seems alright, lets see how long will it last.

so far i can't say anything bad, its all great and of course if any dev comes accord this post. THANK YOU!


First off, Hello. I am new here, LOL.

Right, well I just purchased on of these TP-Link routers (upgrading from a Linksys WRT54G) and I would just like someone to confirm that I have this flashing process correct.

I have the just of everything (quoted above) but I would just like to make sure that there is no "middle man" firmware to flash with this model router like there was with the Linksys WRT54G, correct?

I just flash directly from stock to DD-WRT?
Armethyst
DD-WRT User


Joined: 03 Jun 2011
Posts: 64

PostPosted: Fri Aug 09, 2013 15:52    Post subject: Reply with quote
Just like the instructions
You have two files in every released firmware
One is for factory-stock to ddwrt and another for web upgrade
Just use the factory to ddwrt and you'll do just fine
Check your serial before to make sure it's within range of someone who's already did the conversion to ddwrt
cliggity
DD-WRT Novice


Joined: 09 Aug 2013
Posts: 29
Location: MI, USA

PostPosted: Fri Aug 09, 2013 16:29    Post subject: Reply with quote
Armethyst wrote:
Check your serial before to make sure it's within range of someone who's already did the conversion to ddwrt
I don't have serial. Is it required?
PsSparky
DD-WRT Novice


Joined: 24 Jul 2012
Posts: 9

PostPosted: Sat Aug 10, 2013 10:44    Post subject: Reply with quote
Does anyone have any experience with version 1.9? Does it work with DD-WRT at all?

EDIT: Just found this post with instructions by "NySaU1gX". Over on this topic, page 113: http://www.dd-wrt.com/phpBB2/viewtopic.php?p=712604

So first you'll have to flash the german firmware?
checho
DD-WRT Guru


Joined: 27 Feb 2007
Posts: 527
Location: Bulgaria

PostPosted: Sat Aug 10, 2013 11:09    Post subject: Reply with quote
PsSparky wrote:
Does anyone have any experience with version 1.9? Does it work with DD-WRT at all?

EDIT: Just found this post with instructions by "NySaU1gX". Over on this topic, page 113: http://www.dd-wrt.com/phpBB2/viewtopic.php?p=712604

So first you'll have to flash the german firmware?


Flash build 22118 on the device without anything before that. No special manipulation is needed. 1.9 is supported as it is one and same hardware. Only the first digit means something that concerns hardware so they all are v1. The thing with flashing the german firmware addresses a problem that is now fixed from several builds of dd-wrt to now. So it is neither obligatory nor recommended to do it.
PsSparky
DD-WRT Novice


Joined: 24 Jul 2012
Posts: 9

PostPosted: Sat Aug 10, 2013 11:19    Post subject: Reply with quote
checho wrote:
PsSparky wrote:
Does anyone have any experience with version 1.9? Does it work with DD-WRT at all?

EDIT: Just found this post with instructions by "NySaU1gX". Over on this topic, page 113: http://www.dd-wrt.com/phpBB2/viewtopic.php?p=712604

So first you'll have to flash the german firmware?


Flash build 22118 on the device without anything before that. No special manipulation is needed. 1.9 is supported as it is one and same hardware. Only the first digit means something that concerns hardware so they all are v1. The thing with flashing the german firmware addresses a problem that is now fixed from several builds of dd-wrt to now. So it is neither obligatory nor recommended to do it.



Thanks mate really appreciate your help.

So just to confirm: im safe to flash the r22118 version of DD-WRT even though my serialnumber starts with 12xxxxx and im using HW ver 1.9?
tilator
DD-WRT Novice


Joined: 29 Jun 2008
Posts: 9

PostPosted: Sat Aug 10, 2013 13:42    Post subject: Password Reply with quote
Maybe you all already know this, but factory firmware root passwd is 5up.

It's possible to log in as root with it using serial connection.

I suppose the same password is used in some other TP-Link models too.
checho
DD-WRT Guru


Joined: 27 Feb 2007
Posts: 527
Location: Bulgaria

PostPosted: Sat Aug 10, 2013 14:54    Post subject: Reply with quote
PsSparky wrote:
Thanks mate really appreciate your help.

So just to confirm: im safe to flash the r22118 version of DD-WRT even though my serialnumber starts with 12xxxxx and im using HW ver 1.9?


Yes.
cliggity
DD-WRT Novice


Joined: 09 Aug 2013
Posts: 29
Location: MI, USA

PostPosted: Sun Aug 11, 2013 1:17    Post subject: All good Reply with quote
Thanks for the help guys. After a few snags, I got the router flashed with version 22118, but after thumbing through the admin page, I have noticed a minor ache.

I see that the TX Power is now displayed in DB. Is there a setting to change or command that I can run to revert to the old Milliwatt format?

Thanks again.
shft_l2neku
DD-WRT Novice


Joined: 25 Aug 2013
Posts: 2

PostPosted: Sun Aug 25, 2013 11:06    Post subject: Unable to access config page Reply with quote
Hello, I'm new to this forum and I flashed my 1043ND rev1.8 about a year ago now.

Things were going well for a long time, so long that I didn't have to manage the router for several months at a time. However, I discovered a few days ago that when I try to access the config page using the gateway IP, it fails to return the admin page.

I've tried to ping the gateway IP and I can confirm that it works.

That's all I know so far.

Help Please! and Thank You.

EDIT:
forgot to mention, SYS led doesn't light up again (after power on)
agent.milkins
DD-WRT Novice


Joined: 30 Mar 2013
Posts: 2

PostPosted: Sun Sep 15, 2013 14:06    Post subject: TP-Link 1043ND (rev. 1.9) - successful flash Reply with quote
Hi everybody!

I have just successfully flashed my TP-Link 1043ND (HW rev. 1.9) with DD-WRT v24-sp2 (07/24/13) std - build 22118.

This is just to let everybody know that this combination works fine and I have not seen any problems so far.

I have used the webflash bin file downloaded from here:
ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2013/07-24-2013-r22118/tplink_tl-wr1043nd/


If I see any issues in the future I will let you know in this post.
Goto page Previous  1, 2, 3, 4, 5, 6, 7  Next Display posts from previous:    Page 6 of 7
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Atheros WiSOC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum