[avecuny]

Hello, (first post on this forum - please apologize if i posted in the wrong sub-forum)

I've set up a repeater-bridge config and i'd like to know which configuration option or setup could allow me to make the repeater (secondary router) and its clients invisible to the clients of the primary router.

Thank you!

BTW, just our of curiosity; i had a lot of issues with the WEP authentication, and i figured (after a lot of trials and errors) that the Ascii passphrase was not recognised... i had to use the Hex key, any idea why?

[yzy-oui-fi]

First you are in french section! :)

So to answer your question , i guess you are looking for repeater which is a NAT system (not repeater bridge).

This system will masquerade all repeater clients behind the wan ip address of your device