have you read the Peacock thread, which is third announcement in tne Broadcom Forum section? after you read it check out link below, it may help. you can't flash mega until you have installed/flashed mini. did you set your computer to a static IP? i am using a belkin f7d7301. also you have to use a trailed build with your router's name in the build. such as-
Once you have both files you will need to log into the belkin firmware at 192.168.2.1. And set the factory defaults. Once that is done do a 30/30/30 reset (Hold Reset Button 30 secs, unplug power with reset button still held in... keep power out for 30, and plug power back in while still holding the reset for 30 more seconds)
Once that is done make double sure that your PC IP address is wired directly to the router, and that you have a static IP address of 192.168.2.8 with subnet 255.255.255.0
If you double checked and it's right refresh your browser at 192.168.2.1. You should now see a CFE Web Browser page that tells you to browse for a file.
Browse for the file and point it to the mini build first. Click upload it should tell you that it received the upload and it's now rebooting. At this point in time *VERY IMPORTANT* go take a smoke break make some coffee or do something else for the next 5 to 10 minutes, make sure you don't reset the router etc.
Once you're back from your coffee / smoke break, change the ip address on your pc to 192.168.1.8 with the same subnet of 255.255.255.0
You should now see DD-WRT firmware. Now change the root password make sure you save stuff and then from the administration tab click on firmware upgrade
At this time point it to the mega build and click upgrade. This will take another 6 or so minutes roughly, so it's time for a beer as you're almost done...
Once this completes you should be in eko's new mega build!
Enjoy! Let us know if you have issues.
PS: Reason why there is no instructions on wiki yet is because I just recently finished helping the tests for the router along with Eko and perhaps some others.
PERFECT!!!
you should use IE instead of Firefox (in case you forgot)
Thank you so much
Posted: Mon Dec 04, 2017 16:50 Post subject: Mega dd-wrt
Be careful with mega dd-wrt, that router as only an 8MB flash, all builds that you put on it must be less than 8 000 000 bytes. Check before you flash or you will brick the router instantly, requiring Serial or JTAG recovery. _________________ Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
QCA Best WiFi Settings
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one.
Atheros:
Netgear R7800 x3 - WDS AP / station, gateway, QoS
TP-Link Archer C7 v2 x2 - WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - NU
D-Link 615 C1/E3/I1 x 7 - 1 WDS station
D-Link 825 B1 - NU
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - NU
UBNT loco M2 x2 - airOS
Broadcom
Linksys EA6400 - Gateway, QoS
Asus N66U - AP
Netgear WNDR3700v3 - not used
MediaTek
UBNT EdgeRouter X - switch
