Once i figured this out I was enable to follow the rest of the steps and make my HP PSC 1200 series printer work on both my desktop and my girlfriends laptop.
The problem however comes up whenever i actually print something.
large print jobs never start (10MB+), and small print jobs (500KB-2MB) only print half way before the printer stops dead in it's tracks.
The print job fails, and I have to restart the print spooler to get rid of the old job.
However, when the print job dissapears the printer prints the exact same as it did on the job i just canceled.
No idea why, it even stops at the very same line as the previously failed print job.
the length of the print job seems to vary slightly depending on if i set the printer to "start printing after the last paged is spooled" or "start printing immediately"
I tried to bypass the spooler by allowing the PC to send the entire print job directly to the printer, only to find the application printing hangig on 50% CPU, or 1 core if you will.
I am getting the same thing with my wndr3700, printing only gets through half a page on my psc1210. I dont think its the printer, since it works if plugged in normally. it's got to be communication between the computer->router->printer
Set up as in this excellent article. Vista Home premium 64-bit. Point driver to router port 9100 as described, print test page and works just fine! But print from any other application (browser, MS Word 2003, PDF docs, etc.) and print job disappears from spool queue on laptop with no response from printer. Print another test page right away and it works.
Hmmmm.... Any ideas?
Thx
Just followed your tutorial using p910nd_0.95-1_atheros.ipk.
root@cv:~# cd /jffs
root@cv:/jffs# ls
p910nd_0.95-1_atheros.ipk tmp
root@cv:/jffs# ipkg install p910*
ERROR: File not found: //usr/local/lib/ipkg/lists/whiterussian
You probably want to run `ipkg update'
ERROR: File not found: //usr/local/lib/ipkg/lists/non-free
You probably want to run `ipkg update'
ERROR: File not found: //usr/local/lib/ipkg/lists/backports
You probably want to run `ipkg update'
/bin/ipkg: line 1184: sort: not found
Unpacking p910nd...Done.
Configuring p910nd...Done.
root@cv:/jffs#
I have ignored the errors and the printer worked OK.
Posted: Thu Jan 24, 2013 10:13 Post subject: Printer stops halfway
Same problem here as above:
installed printer on WRT160nl, ingnored errors and connected a DYMO LABELWRITER450 to the router. It's detected and everything seems ok.
I installed the printer within Windows using the guide and when I print the DYMO does print a part but then stops. When I print again the whole label is printed at the remaining part of the label and then a blank label is fed.
It looks like the first printjob stops but the second succeeds (but now I have 1,5 job on 1 label).
Tried disabling bi-directional and setup 'print directly' but no success...