[monkey243]

Starting EthAcc component ...
0x1fffe68 (tRootTask): ixQMgrInit: IxQMgr initialise
ixe ETH PHY 0 Hard Coded MAC address is: 00:12:17:3b:c7:d2
ixe ETH PHY 1 Hard Coded MAC address is: 00:12:17:3b:c7:d3











VxWorks System Boot


Copyright 1984-2002 Wind River Systems, Inc.





CPU: WRT54GP2A-AT
Version: VxWorks5.5.1
BSP version: 1.3/3
Boot version: 0.00.e
Creation date: Sep 21 2004, 16:38:09




Press any key to stop auto-boot...
0
auto-booting...


boot device : tffs:
unit number : 0
processor number : 0
file name : /fl/vxWorks.sys
inet on ethernet (e) : 192.168.1.1:ffffff00
host inet (h) : 192.168.1.100
user (u) :
ftp password (pw) :
flags (f) : 0x80
target name (tn) : targetname
other (o) : ixe0

Attaching to TFFS... done.
Loading /fl/vxWorks.sys... 3300940
Starting at 0xa80000...



PCI Device Table
---------------------------------------
Bus Slot Func Vendor Device BAR
=== ==== ==== ====== ====== ==========
00 00 00 0x17fe 0x2220 0x100000
---------------------------------------

Host Name: bootHost
Starting EthAcc component ...
0x1fffe68 (tRootTask): ixQMgrInit: IxQMgr initialise
ixe ETH PHY 0 Hard Coded MAC address is: 00:12:17:3b:c7:d2
ixe ETH PHY 1 Hard Coded MAC address is: 00:12:17:3b:c7:d3
Return ixp425 wlan name string..
Parsed unit number 0
Start call i2220ap_priv_create
End call i2220ap_priv_create
Mem setup complete
Done load Wlan
Attached TCP/IP interface to ixe unit 0
Attaching network interface lo0... done.
Multicast MAC: 01:00:5e:00:00:01 ( ff:ff:ff:ff:ff:ff )
Constituent Addresses:
01:00:5e:00:00:01

Adding 21891 symbols for standalone.


]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
]]]]]]]]]]] ]]]] ]]]]]]]]]] ]] ]]]] (R)
] ]]]]]]]]] ]]]]]] ]]]]]]]] ]] ]]]]
]] ]]]]]]] ]]]]]]]] ]]]]]] ] ]] ]]]]
]]] ]]]]] ] ]]] ] ]]]] ]]] ]]]]]]]]] ]]]] ]] ]]]] ]] ]]]]]
]]]] ]]] ]] ] ]]] ]] ]]]]] ]]]]]] ]] ]]]]]]] ]]]] ]] ]]]]
]]]]] ] ]]]] ]]]]] ]]]]]]]] ]]]] ]] ]]]] ]]]]]]] ]]]]
]]]]]] ]]]]] ]]]]]] ] ]]]]] ]]]] ]] ]]]] ]]]]]]]] ]]]]
]]]]]]] ]]]]] ] ]]]]]] ] ]]] ]]]] ]] ]]]] ]]]] ]]]] ]]]]
]]]]]]]] ]]]]] ]]] ]]]]]]] ] ]]]]]]] ]]]] ]]]] ]]]] ]]]]]
]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
]]]]]]]]]]]]]]]]]]]]]]]]]]]]] Development System
]]]]]]]]]]]]]]]]]]]]]]]]]]]]
]]]]]]]]]]]]]]]]]]]]]]]]]]] VxWorks version 5.5.1
]]]]]]]]]]]]]]]]]]]]]]]]]] KERNEL: WIND version 2.6
]]]]]]]]]]]]]]]]]]]]]]]]] Copyright Wind River Systems, Inc., 1984-2003

CPU: Processor #0.
Memory Size: 0x2000000. BSP version 1.3/3.

check file system now !
dosChkLib : CLOCK_REALTIME is being reset to SUN AUG 02 15:51:52 2009
Value obtained from file system volume descriptor pointer: 0x17dfef0
The old setting was THU JAN 01 00:00:00 1970
Accepted system dates are greater than THU DEC 27 00:00:00 1990
/fl/ - Volume is OK
ixdp425EthEndStartUp: Forcing Hard Coded IP Address for ixe1
Multicast MAC: 01:00:5e:00:00:01 ( ff:ff:ff:ff:ff:ff )
Constituent Addresses:
01:00:5e:00:00:01
ixdp425EthEndStartUp: ixe1: IP Addr set to 192.168.60.1
bridgePortAdd ******** for ixe0*****************
Return ixp425 wlan name string..
bridgePortAdd ******** for Frisbee0*****************
_____________ get mac[4] = 0xc7 mac[5] = 0xd2
_____________ get mac[4] = 0xc7 mac[5] = 0xd2
-> prio = 150,snmpdTaskOptions=0,stackSize=28672,traceLevel Log Length=0
Start Initial MEM Drv
Copy OK: 0 bytes copied
CC module initialized successfully
FlshFormatFileSystem: Invalid Filesys ID -1
Primary Database File System Is Not Formatted
FlashVerifyCheckSum: file /mem/pricf/0 does not exist
vxBitsInit
Return ixp425 wlan name string..
aIfName = mirror0
Return ixp425 wlan name string..
!!!!!!!!!!!!!!Find Interface mirror0
aIfName = ixe1
!!!!!!!!!!!!!!Find Interface ixe1
Return ixp425 wlan name string..
aIfName = Frisbee0
Error 0xffffffff Couldn't add Input Hooks

WAN Initialisation [SUCCESS]
PPPoE Initialised
PPTP Initialised
L2TP Initialization success
Firewall INIT completed
AD Init completed FW initalized


** before calling dhcpc http register function **

TFTPD:Initializatinion ok ...............
IGWIpRsmInit(): ....End

Initialising UPnP Stack DEBUG: IGWHttpServStart: server is now running

UPnP Stack InitialisedRegistered MsgClnt
load<==>ulTotalLen = 1708, ulFlashchecksum=133958, ulCheckSum = 20b46
IGWUPNLdSvInit 54

IGWIGDLoadAndSaveInit: success
../../ldsvcbk/firewall/kukildsv.c(76): FWCookieLdsvInit: SUCCESS



***********************************************************
* LDSV VERSION [1.6] *
* Flash is Emply .... Loading Default *
***********************************************************

LoadTimeZone: DbGetRecordInfo Failed Unable to load the user database
Loading IP address : IP address of ixe1 is Dynamic, kicking message to DHCPC
IpLoadRoute:DbGetRecordInfo() failed..
standard_tftp_seError in loading IP Routing datrver launched on port abase
69Error in loading RIP config.
uration records.
Error in loading RIP database
Return ixp425 wlan name string..
Return ixp425 wlan name string..
DNSRDLoad Done
DNSRDLoadSysDName Done

ADTcpRstTmoutLoad: DbGetRecordInfo Failed
ADPxyLoad: DbGetRecordInfo Failed
Firewall load database completed Error in loading Security database
Dns ALG loaded
IGWIGD: Loading data
lTotalRecs is -1

IGWIGDLoadIface: DbGetRecordInfo() failed UPnPPeriodicAdvertiseRestatr: Starting Advt.

IGWIGDLoad: IGWIGDLoad() failed for Iface
IGWUPN: Loading data
IGWUPNLoadData 74
IGWUPNLoadHostRec 266

IGWUPNLoadHostRec: DbGetRecordInfo Failed IGWUPNLoadServRec 352

IGWUPNLoadServRec: DbGetRecordInfo Failed
test 2 - fffffff7 = b
Sucess Init Wireless.

FwLoadAllCookieRec: DbGetRecordInfo Failed
FwLoadCfgFlagsOfAllCookieLists: DbGetRecordInfo Failed
RMLoad: DbGetRecordInfo Failed Httpd_Register_TagArray
Wake up packet recvived
index = 1
DLcid 02050100-01
********************************************
* Intel IXP400 DSP Software *
* Release 2.5 EAR *
* Jan 23 2004, 16:27:18 *
* Intel Corporation *
********************************************

Initializing Slic's, please wait...
UPnPPeriodicAdvertiseRestatr: Starting Advt.

-> help

help Print this list
ioHelp Print I/O utilities help info
dbgHelp Print debugger help info
nfsHelp Print nfs help info
netHelp Print network help info
spyHelp Print task histogrammer help info
timexHelp Print execution timer help info
h [n] Print (or set) shell history
i [task] Summary of tasks' TCBs
ti task Complete info on TCB for task
sp adr,args... Spawn a task, pri=100, opt=0x19, stk=20000
taskSpawn name,pri,opt,stk,adr,args... Spawn a task
td task Delete a task
ts task Suspend a task
tr task Resume a task
d [adr[,nunits[,width]]] Display memory
m adr[,width] Modify memory
mRegs [reg[,task]] Modify a task's registers interactively
pc [task] Return task's program counter

Type <CR> to continue, Q<CR> to stop: cr

iam "user"[,"passwd"] Set user name and passwd
whoami Print user name
devs List devices
ld [syms[,noAbort][,"name"]] Load stdin, or file, into memory
(syms = add symbols to table:
-1 = none, 0 = globals, 1 = all)
lkup ["substr"] List symbols in system symbol table
lkAddr address List symbol table entries near address
checkStack [task] List task stack sizes and usage
printErrno value Print the name of a status value
period secs,adr,args... Spawn task to call function periodically
repeat n,adr,args... Spawn task to call function n times (0=forever)
version Print VxWorks version info, and boot line

NOTE: Arguments specifying 'task' can be either task ID or name.

value = 1 = 0x1
-> ls
vxworks.sys
igwhtmB.dat
igwpricf.dat
htpscert.dbm
vxworksb.sys
igwhtm.dat
bddata.txt
root.crt
public.crt
private.derkey
WANIP.txt
ProvUrl.txt
help
value = 0 = 0x0
->

all the files above can be download by tftp.



break normal, I find the following infomation:

[VxWorks Boot]: ?

? - print this list
@ - boot (load and go)
p - print boot params
c - change boot params
l - load boot file
g adrs - go to adrs
d adrs[,n] - display memory
m adrs - modify memory
f adrs, nbytes, value - fill memory
t adrs, adrs, nbytes - copy memory
e - print fatal exception
v - print boot logo with version
n netif - print network interface device address
$dev(0,procnum)host:/file h=# e=# b=# g=# u=usr [pw=passwd] f=#
tn=targetname s=script o=other
boot device: tffs=drive,removable file name: /tffs0/vxWorks
Boot flags:
0x02 - load local system symbols
0x04 - don't autoboot
0x08 - quick autoboot (no countdown)
0x20 - disable login security
0x40 - use bootp to get boot parameters
0x80 - use tftp to get boot image
0x100 - use proxy arp

available boot devices:Enhanced Network Devices
ixe0 ixe1 tffs
[VxWorks Boot]: p

boot device : tffs:
unit number : 0
processor number : 0
file name : /fl/vxWorks.sys
inet on ethernet (e) : 192.168.1.1:ffffff00
host inet (h) : 192.168.1.100
user (u) :
ftp password (pw) :
flags (f) : 0x80
target name (tn) : targetname
other (o) : ixe0

[VxWorks Boot]:


I have tried to make it boot from tftp and it did. But it just downloade the boot image from tftp, but never can boot.
Hope it can help.

[Sash]

in any case u need redboot installed to get an alternative os running. see the openwrt wiki