the installation instructions should be in the install section of the wiki, for your router. Also read the announcements at the top of this forum carefully. _________________ SIG:
I'm trying to teach you to fish, not give you a fish. If you just want a fish, wait for a fisherman who hands them out. I'm more of a fishing instructor.
LOM: "If you show that you have not bothered to read the forum announcements or to follow the advices in them then the level of help available for you will drop substantially, also known as Murrkf's law.."
Try the mini first. Remember to follow the installation instructions in the wiki. Pay special attention to the parts about the hard reset, and when you actually upload the firmware, WAIT.
thanks for your information, It is sure I got wrt54g V2
I plan to flash it with Web GUI
Please clarify my step
1/ Use Hard reset or 30/30/30 to reset to Factory Defaults.
2/ Type in the IP address of the router (typically, the default is 192.168.1.1, especially with Linksys) into the address bar of your browser.
3/ Click the "Administration" tab
4/ Click the "Firmware Upgrade" sub-tab.
5/ Click the "Browse" button and select the DD-WRT .bin file you downloaded and confirmed.
Click the "Upgrade" button.
6/ Lastly, do another hard reset on the unit.
If flashed successfully you will now be able to access the DD-WRT web interface at 192.168.1.1 (again, that is default for most Linksys, etc routers; does not apply to all routers. Check your router's IP before you start this process - clock).
thanks for your information, It is sure I got wrt54g V2
I plan to flash it with Web GUI
Please clarify my step
1/ Use Hard reset or 30/30/30 to reset to Factory Defaults.
2/ Type in the IP address of the router (typically, the default is 192.168.1.1, especially with Linksys) into the address bar of your browser.
3/ Click the "Administration" tab
4/ Click the "Firmware Upgrade" sub-tab.
5/ Click the "Browse" button and select the DD-WRT .bin file you downloaded and confirmed.
Click the "Upgrade" button.
6/WAIT AT LEAST FIVE MINUTES.
7/ Lastly, do another hard reset on the unit.
If flashed successfully you will now be able to access the DD-WRT web interface at 192.168.1.1 (again, that is default for most Linksys, etc routers; does not apply to all routers. Check your router's IP before you start this process - clock).