also for me there is tx power problem on EOC-1650.
two eoc1650:
one with 03/14/09 (SVN revision: 11762) default config tx 20db
other with original firmware default config tx 20db
i have the same problem of zx6rbarry.
and also in this release the status wireless page is always 20dbm
Did you guys switch RX and TX Antenna to SECONDARY?
I am using the 1650 with internal Antenna and Antenna-Settings set to SECONDARY.
Don't trust what the Status>Wireless in the 1650 is saying.
Check the SNR on your AP.
Had the Internal Antenne and set to Primary in DD-wrt.
result: Nice SNR in Wireless>status of the EOC (around 30) but bad SNR in my AP (SNR of 3 only).
Internet was really bad when set to Primary.
Funny is: I use the 2610 with EXTERNAL Antenna and set to Secondary in dd-wrt.
The 1650 with INTERNAL set to Secondary also.
Enrico, Your results are really bad.
Either the 1650 isn't as good as i expacted or the Buffalo HP 54 ist just awesome.
Hi,
On my EOC-1650 with DD-WRT v24-sp2 (03/19/09)
have Antenna Output Internal/External and on device
a little switch with INT/EXT, so it's perfect BUT
i still have problem with bad snr
I can confirm the same problem. Same place with a Buffalo WHR-HP-G54 gives much better signal than the Senao. I've tried different power levels and the signal vary, but it never reach Buffalo levels.
Try the lastest Build:
03/25/09
since 03/19/ had a Bug!
Important: After update go to Wireless>Basic and Set the TX and RX Antenna again as you prefer and hit APPLY.
Doesn't matter if the right Antenna is already chosen. Just select and hit Apply again!
You can now even use a negative Antenna Gain like -5.
So you will get the rest out of your EOC 1650.
This works with the 2610 now, too.
Post your results here, please!!!
Last edited by movozo on Wed Mar 25, 2009 14:29; edited 1 time in total