BS 11697 is out!

Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware
Goto page 1, 2, 3, 4  Next
Author Message
Slione
DD-WRT User


Joined: 05 Dec 2007
Posts: 215
Location: Michigan

PostPosted: Sat Feb 28, 2009 13:52    Post subject: BS 11697 is out! Reply with quote
Up and running on my sig router!
_________________
WRT1900AC v1-build r30731
Sponsor
barryware
DD-WRT Guru


Joined: 26 Jan 2008
Posts: 13049
Location: Behind The Reset Button

PostPosted: Sat Feb 28, 2009 14:22    Post subject: Reply with quote
Damn.... There goes my uptime again.
_________________
[Moderator Deleted] Shocked
dellsweig
DD-WRT Guru


Joined: 07 Jun 2006
Posts: 1476
Location: New York, USA

PostPosted: Sat Feb 28, 2009 14:32    Post subject: Re: BS 11697 is out! Reply with quote
Slione wrote:
Up and running on my sig router!


Just upgraded my WRT310N's - AP and Client Bridge.

My wireless to LAN speed dropped dramatically - back to where we were 2 builds back

i will keep testing
redhawk0
DD-WRT Guru


Joined: 04 Jan 2007
Posts: 11564
Location: Wherever the wind blows- North America

PostPosted: Sat Feb 28, 2009 14:32    Post subject: Reply with quote
So far...so good.

R, RB, CB and host AP all running well.

no micro builds tested....I run all Plus builds and BS doesn't supply them.

redhawk

_________________
The only stupid question....is the unasked one.
redhawk0
DD-WRT Guru


Joined: 04 Jan 2007
Posts: 11564
Location: Wherever the wind blows- North America

PostPosted: Sat Feb 28, 2009 14:37    Post subject: Reply with quote
Yep...spoke too soon.

LAN to WAN speeds are about 1/2 of what they were in 11667.....very noticeable with R and RB connected units.

instead of 50% BW throughput....I am getting 25-30%.

I too will keep testing for now.

redhawk

_________________
The only stupid question....is the unasked one.
barryware
DD-WRT Guru


Joined: 26 Jan 2008
Posts: 13049
Location: Behind The Reset Button

PostPosted: Sat Feb 28, 2009 15:04    Post subject: Reply with quote
My test is to strem media to an extender.. GUI shows full speed, extenders shows great signal strength but several lost connections reported by the extender.

Red... Did your device(s) reboot themselves after flashing? My GL didn't. Waited about 5 minutes then power cycled it.

_________________
[Moderator Deleted] Shocked
stalonge
DD-WRT Guru


Joined: 21 Jul 2006
Posts: 1898
Location: Fortaleza Ce Brazil

PostPosted: Sat Feb 28, 2009 15:06    Post subject: Reply with quote
I flashed mini_generic and voip_generic ..

both running fine .. i will check the speed to see if it happens here

Very Happy Very Happy

_________________
DDwrt ...it rocks ....

1 R7800 54420 AP Wireguard webserver JFFS SAMBA FTP usb HD Mesh
1 R7800 54420 Cli Mesh
1 WZR1750 54389 AP Webserver Samba Wireguard
1 TP link Archer C7v5 54420 Cli Mesh
1 DD x86_64 48296 Gateway Samba Ftp Webserver
redhawk0
DD-WRT Guru


Joined: 04 Jan 2007
Posts: 11564
Location: Wherever the wind blows- North America

PostPosted: Sat Feb 28, 2009 15:09    Post subject: Reply with quote
barryware wrote:
My test is to strem media to an extender.. GUI shows full speed, extenders shows great signal strength but several lost connections reported by the extender.

Red... Did your device(s) reboot themselves after flashing? My GL didn't. Waited about 5 minutes then power cycled it.


Yes...every unit rebooted itself.

Its kinda strange to see only my R and RB Internet speeds at 25-30%. (Its still in the 4-5Mbps range so it isn't painful...just noticeable)

[EDIT] - BTW...I am running Std on my GLv1.1 unit.

redhawk

_________________
The only stupid question....is the unasked one.
stalonge
DD-WRT Guru


Joined: 21 Jul 2006
Posts: 1898
Location: Fortaleza Ce Brazil

PostPosted: Sat Feb 28, 2009 15:51    Post subject: Reply with quote
My 2 whrg125 are working for 1 hour .. so far so good
_________________
DDwrt ...it rocks ....

1 R7800 54420 AP Wireguard webserver JFFS SAMBA FTP usb HD Mesh
1 R7800 54420 Cli Mesh
1 WZR1750 54389 AP Webserver Samba Wireguard
1 TP link Archer C7v5 54420 Cli Mesh
1 DD x86_64 48296 Gateway Samba Ftp Webserver
rkozola
DD-WRT User


Joined: 27 Oct 2007
Posts: 152

PostPosted: Sat Feb 28, 2009 15:51    Post subject: Reply with quote
this build + WRT350N = BAD

ticket created. switch driver fails to load.


...
Booting device: Linksys WRT350N
loading bcm57xxlsys
robo_enable_device: enabling RvMII mode failed
...
stalonge
DD-WRT Guru


Joined: 21 Jul 2006
Posts: 1898
Location: Fortaleza Ce Brazil

PostPosted: Sat Feb 28, 2009 16:43    Post subject: Reply with quote
2 hours .. everything seems fine with both routers ..

Maybe cause its a buffalo whrg125 .. the BS hardware test ...


Very Happy Very Happy

_________________
DDwrt ...it rocks ....

1 R7800 54420 AP Wireguard webserver JFFS SAMBA FTP usb HD Mesh
1 R7800 54420 Cli Mesh
1 WZR1750 54389 AP Webserver Samba Wireguard
1 TP link Archer C7v5 54420 Cli Mesh
1 DD x86_64 48296 Gateway Samba Ftp Webserver




Joined: 01 Jan 1970
Posts:

PostPosted: Sat Feb 28, 2009 16:50    Post subject: Reply with quote
WRT300Nv1 working fine.
GRouter
DD-WRT Novice


Joined: 11 Aug 2007
Posts: 40

PostPosted: Sat Feb 28, 2009 17:41    Post subject: Reply with quote
installed nicely on my WRT610N
only tested wl0 G and it seems to have a signal a lot stronger then before..
gene
DD-WRT Guru


Joined: 28 Dec 2007
Posts: 619

PostPosted: Sat Feb 28, 2009 17:49    Post subject: Reply with quote
barryware wrote:
Damn.... There goes my uptime again.
same here, 11667 up and running for 7 days flawlessly except for UPnP. I see no reports for UPnP for this build so I guess I'll test it on my sig hardware.

EDIT:
OK, at first blush, UPnP does not seem to work in this build either, then I decide to use another test to see if UPnP works. I was using XBOX360 to see if an entry was made in UPnP web GUI, No XBOX360 entry made, so I switched to utorrent and voila, UPnP web gui shows utorrent entry. so I'm confused, an XBOX360 has always inserted a UPnP forward even tho port forwarding was properly enabled for this xbox, UPnP was just a back-up for the 360. I guess UPnP checks to see if any ports need to be opened/forwarded now ???(I did not forward any ports for utorrent, utorrent did the job) So why is the xbox no longer making any entries in UPnP web gui ?

aside from that everything else looks good.

another edit:
Utorrent test made from WINXP, decided to test from linux with transmission and UPnP also works there. So I'm really baffeled, why xbox no longer registers with UPnP.

_________________
1 WRT160N v3 - remote AP WPA2 Personal Aes dd-wrt-mini-trailed CPU OC400,
2 wrt54G v3(BCM4712 chip rev 1, corerev=7)- AP WPA2 Personal Aes dd-wrt-mini-generic CPU OC228,
1 wrt54gs v6 - remote AP WPA2 Personal Aes dd-wrt-micro CPU OC228 ,
3 WAP54g v3 - repeater, client Bridge, repeater bridge dd-wrt-micro CPU OC225,
1 NetGear WNR2000 v3 AP Atheros AR7241 ver 1 rev 1.1 (0x0101) Trailed build CPU OC360
DD-WRT usually the most current BS builds and less frequently lately EKO builds(because of new BS rules that eliminated EKO builds I used).
rhdcheme
DD-WRT User


Joined: 16 Jun 2007
Posts: 168
Location: Northern Virginia, USA

PostPosted: Sat Feb 28, 2009 19:24    Post subject: Reply with quote
rkozola wrote:
this build + WRT350N = BAD

ticket created. switch driver fails to load.


...
Booting device: Linksys WRT350N
loading bcm57xxlsys
robo_enable_device: enabling RvMII mode failed
...


Hope it gets fixed soon.

_________________
E3000 (converted from WRT610NV2)
ASUS RT-N56U Firmware 1.0.1.4 (reverted from 1.0.1.5)
Goto page 1, 2, 3, 4  Next Display posts from previous:    Page 1 of 4
Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum