Joined: 07 Jun 2006 Posts: 1476 Location: New York, USA
Posted: Fri Feb 13, 2009 12:57 Post subject:
snooze7555 wrote:
phuque99 wrote:
Seems like BS has updated a new folder with the same date (130209).
I use always the EKO builds because when i use Sebastians (BS) builds then i have problems with wds WPA2 AES. Not always but often
Loaded this Eko build on the following:
WRT54GL - Mini build Repeater Bridge
WRT54GV4 - Mini Build AP (no DHCP)
WRT310N - Std NoKaid build - Main AP - N only
WRT310N - mini build - Client Bridge - N only
Flash was uneventful. I do have the following to report
1) CIFS GUI will not mount windows shared file system
I did not see anything useful in the syslog data.
2) Wide Channel N - WLAN to WAN thruput is half the 20Mhz single channel rate. This is an on-going issue
Joined: 18 Jan 2008 Posts: 269 Location: Devon, PA USA
Posted: Fri Feb 13, 2009 13:41 Post subject:
I just upgraded all 3 of my routers, no problems so far. _________________ 2 x wrt600n v1.1 AP WL0 Mixed Mode WPA2 Pers Aes, WL1 N Only Repeater Bridge WPA2 Pers AES V24 BS 15778 WT610N
wrt310n Wireless Bridge WPA2 Pers AES v24 BS 15506 Mini
wrt54g v7 G Only Repeater Bridge WPA2 Pers AES v24 BS 12523 Micro
Joined: 04 Jan 2007 Posts: 11563 Location: Wherever the wind blows- North America
Posted: Fri Feb 13, 2009 13:56 Post subject:
OK...so far 11604 is impressing me.
WAN and LAN speeds seem good on B/G units
Flash upgrades working properly (reboots automatially when the flash finishes)
Web Gui interface is a bit quicker than it was previously
I don't have to do any extra steps to get the 614L loaded.
My RB to RB link is working as it should too...no need to power cycle the far unit after the middle unit is taken off line...its now automatically reconnected.
Nice work devs...this could be my next recommended build if I see stability out of this build.
It appears to be a big improvement from the 113XX-115XX builds.
redhawk _________________ The only stupid question....is the unasked one.