WRT54G2 Client Mode

Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware
Author Message
Folken
DD-WRT Novice


Joined: 13 Feb 2009
Posts: 1

PostPosted: Fri Feb 13, 2009 0:39    Post subject: WRT54G2 Client Mode Reply with quote
Not sure if its been posted but I searched and didn't find anything. But I have been trying to connect a Linksys WRT54G2v1 to a Dlink 54g router using client mode, I followed the instructions given and can get it to connect but I can't seem to download at more then 20KB/s.

I have disabled the SPI Firewall and played with some settings to no avail.

Any suggestions to up the download speed are much appreciated, Thanks in advance. Smile
Sponsor
alain
DD-WRT Guru


Joined: 06 Jun 2006
Posts: 601

PostPosted: Fri Feb 13, 2009 0:52    Post subject: Reply with quote
What link speed do you get? What are your signal values?
A screenshot of the status page would be helpful.
Donny
DD-WRT Guru


Joined: 13 Nov 2008
Posts: 5266
Location: CENTRAL Midnowhere

PostPosted: Fri Feb 13, 2009 1:40    Post subject: Reply with quote
Check out the peacock thread sticky. Did you do a hard reset after flashing? What build are you using?
_________________
Warning: I'm "out of my element!"
http://www.youtube.com/watch?v=MjYJ7zZ9BRw&NR=1

Peacock Thread Sticky- Just read it! (Anyone using SP1 will be taken out back and shot)
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=51486
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum