Posted: Thu Sep 24, 2009 14:35 Post subject: Disagree.
This is not the place to put flames, if you have a problem with Sash solve it through mp. Also, when I had a question and needed help, I got the reply from BS at 2AM, 5 minutes after asking about the issue.
Every time I found a strange behaviour with a firmware, and that I reported to Eko, we did work together to replicate the issue on his side, and he ALWAYS found a workaround or a solution / new debugged version.
Most of the users dont even look at the beginning of the threads, nor read the Wiki, nor the procedures. So, what do you expect ? That we will lose hours / days to answer lazy people ? Sorry, this is not our role, Sash is a contributor, as most of us, and I believe he has a private life.
Sash, you can delete my post later. No problem.
EDIT: about stability, running more than 10 days without any issue...
look at the picture _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link
Posted: Fri Oct 23, 2009 22:07 Post subject: NOP-8670
I have several NOP-8670 LFP which I would like to use with dd-wrt. I started and followed the instructions recommended in this page for this type of board. The first time all the commands worked, but when I reseted the it went directly to the redboot prompt. Now, when I try to repeat the process I get the following:
RedBoot> ip_address -l 192.168.1.1 -h 192.168.1.11
IP: 192.168.1.1/255.255.255.0, Gateway: 0.0.0.0
Default server: 192.168.1.11, DNS server IP: 0.0.0.0
RedBoot> fis init
About to initialize [format] FLASH image system - continue (y/n)? y
*** Initialize FLASH Image System
Warning: device contents not erased, some blocks may not be usable
... Unlock from 0x50fe0000-0x51000000: .
... Erase from 0x50fe0000-0x51000000: .
... Program from 0x0ffdf000-0x0ffff000 at 0x50fe0000: .
... Lock from 0x50fe0000-0x51000000: .
fis init OK
RedBoot> load -r -b 0x80041000 linux.bin
Using default protocol (TFTP)
Specified address (0x80041000) is not believed to be in RAM - continue (y/n)? y
Alex test ARP1
Alex test ARP2
arp_req.ip = <Not a string: 0xB3A4>
basically the first time I did is to get in into the redboot console. but when I tried to upload its give me an error
only 4096 bytes goes and then the speed get down and show me error.
Also I tried with HTTP Server without sucesfull
Also discarded computer problems tried with 10Mbpshalf, duplex, 100Mbps, half, duplex, and nothings.