Posted: Sat Dec 06, 2008 5:43 Post subject: How to get WHR-G300N running DD-WRT v24 SP2?
Obviously there are a few questions involved:
1. Where to get v24 SP2?
2. What is a serial flash? I need the procedures to flash it...
3. Is the support considered stable for daily use?
SP2 path is in the Peacock Thread Sticky. Serial flash would be through the serial port in your computer to a set of serial pins in your router, if it has one. SP2 is quite stable, but where are you planning to pay for support?
Sorry I am a bit confused on the english- support I mean the level of reliability, as long as its going to run like v24 sp1 on my HP-G54/WRT54GL I would regard that as good enough.
I checked the supported device page but seems currently there is no instruction available.
And is sp2 a released version or its still source version which requires target binary compilation? Where is the Peacock Thread Sticky you talk about?
Ok now that sounds interesting webflash- would that mean can be flashed directly via the web interface without using serial cable? how about the firmware.bin? Wouldn't that be the right file to use tftp flashing process? _________________ Need Routers? Visit our shop!
Seems pretty simple and straightforward but for the moment I intend not to put my new WHR-G300N under the influence of my crappy hands:) No serial port on the back that's for sure anyway.
I know generally how it works. However we still need to know the exact pin layout to get the serial port connected _________________ Need Routers? Visit our shop!