Posted: Thu May 07, 2015 23:18 Post subject: igmp snooping not working? multicast flooding...
I am using a v24-sp2 K3 ARM 25648 build which has a igmp snooping option available under Setup > Networking for the br0 bridge.
I have an IPTV decoder connected to the bridge as well as other computers in the same subnet, when I realized that my build allowed igmp snooping I enabled it to prevent the multicast traffic directed to the IPTV decoder from flooding all the LAN.
However, much to my surprise after activating this option I can see with tcpdump that the UDP multicast traffic is reaching the other computers in the LAN, just as if the igmp snooping was turned off.
I've also realized that the /sys/devices/virtual/net/br0/bridge/multicast_snooping file contains a zero value, but it doesn't help either if I echo a "1" into the file.
My question is: is there any other build where the igmp snooping is working or are there any other actions that have to be taken in order to activate it?
PS. I am aware that I can isolate the IPTV decoder into its own vlan in order to prevent the traffic from reaching other computers, but I would like have all the equipments in the same subnet given that the snooping functionality seems to be available.
I already did that and yes, I can isolate the IPTV traffic into one subnet and prevent the rest of the lan from being flooded (or block the traffic to other subnets/lans, for that matter).
My intention was though to make use of the igmp snooping functionality to have all the devices in the same subnet and the igmp snooper keeping track of the port to which the IPTV decoder is attached by means of igmp control messages. In that case the snooper sends the multicast traffic only to that port, preventing the lan from being flooded.
This is a standard functionality in many stock firmwares and it looked like it was also available in the latests DD-WRT builds (I believe it is incorporated in the kernel), but I can't get it to work.
Has anybody succeeded in making the igmp snooping functionality work?
Posted: Thu Jun 04, 2015 13:25 Post subject: IGMP Snooping
I'm trying to find the source code for the latest version IGMP Snooping. I found this old posting that has an igmp_proxy zip file attached, but I can't seem to locate the latest updated sources. I'm hoping someone can point me in the right direction.
I've been facing this same issue with ATT's Uverse service, and it appears that they use a proprietary version of IGMPv3 that makes it fairly impossible for any non-ATT device to do meaningful IGMP snooping. Not sure if that's the same with your provider, but VLANs are certainly my only option.