Posted: Thu Jun 04, 2015 19:15 Post subject: Configure native pound for multiple webservers (non-optware)
I'm trying to set-up a reverse proxy for multiple webservers like frater did here. But I have a k3.1 build that can't use optware, although it has pound 2.6 pre-installed.
Since pound is pre-installed, I'm trying to figure out how to configure it. Obviously I can't write to the rom, but pound points to /usr/etc/pound.cfg which is read only.
Anyway, I've searched and searched but pound seems to be usually installed as optware and therefore all the configuration posts are optware solutions.
Does anyone know how to configure a native pound install to get the results that frater got? Preferably it would be a script solution that doesn't need a flash drive to hold the configs but my router does have a usb port if that is the only way of achieving it.
Firmware Version: DD-WRT v24-sp2 (05/27/15) big - build 27086M
Kernel Version: Linux 3.10.79 #8147 Wed May 27 07:29:43 CEST 2015 mips