Posted: Fri Jan 09, 2026 9:31 Post subject: New Build - 01/09/2026 - r63295
Welcome to Marvell r63295 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp) 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Debug Analyze: stracetcpdump.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Router Model Linksys WRT1900ACS v2
Firmware Version DD-WRT v3.0-r63295 std (01/09/26)
Kernel Version Linux 6.1.159-rt28 #313 SMP Fri Jan 9 06:18:53 +07 2026 armv7l
Current Time Mon, 12 Jan 2026 07:31:19
Uptime 22:18
update-browser PaleMoon 33.9.1, I switched from Linksys firmware, all ok
connection Type PPPoE - IPv6 Type DHCPv6 with Prefix Delegation 1Gbps
IPv6 Type DHCPv6 with Prefix Delegation-On - all Ok
Operating Mode Gateway/AP
Shortcut Forwarding Engine-On (I don't know what you did but this version works at its full capacity, with Shortcut Forwarding Engine in speedtest I reach 933Mbps again)
Schedule Reboot-On,
Web Access Protocol - HTTPS,
SSH (public key)-all ok
Port Forwarding - all Ok,
USB - System Log -all Ok
Schedule Reboot - At a Set Time - On
Dynamic Domain Name System-ok (No-IP)
WireGuard Tunel- ok
Wireless Interface 5GHz-Wireless Mode AP-Wireless Network Mode-AC/N, Width VHT 80 Mhz-Wireless Channel-36,Extension Channel UU, Short GI, Short Preamble, Single User Beamforming, Radio Scheduling, TX Power-30dBm ,TX Antenna Chains-1+2+3+4, RX Antenna Chains-1+2+3+4, Enable-WPA2 - WPA3 Personal / SAE-CCMP-128 (AES), Regulatory Domain Romania, all-ok
I want to show you two speed tests on the 5Ghz wifi side, it seems that on OpenWr snaphoot it is a little better and the speed on 5Ghz wifi is constant, can be nothing done about this?
it is clear that all consumption is redirected to core 1, in the good times not even 10% of core 1 was requested, I am glad to see that the performance has returned in the speed test
I don't know why, but after rebooting the router performance drop on the cable side in speed test to 880 Mbps, and IPv6 Type DHCPv6 with Prefix Delegation does not work with Dynamic Domain (No-IP), allocates ipv6 but does not pass ipv6 test _________________ Internet provider https://en.wikipedia.org/wiki/RCS_%26_RDS 1Gbps
WDR3600 rev.1.5 - DD-Wrt
Linksys WRT1900ACS v.2 DD-Wrt/-OpenWrt
GL-MT6000 OpenWrt
