[mono]

I've got build 58362 on a D-Link DIR-882.

I can't seem to figure out how to set static IP addresses for clients. This is not something I'm new at, rather there are no boxes present to do it. I've never done it before on this build of DD-WRT, on this router. DHCP is working fine otherwise.

I tried 3 different browsers, might be lack of sleep but what am I missing? Below is a screenshot showing Static Leases, with no boxes to input, nor Add/Remove buttons.

I did search for this and looked at the wiki and don't see anything that stands out.

[mono]

Okay I figured it out. Dark browser mode is hiding a change in the interface, where there is no longer Add and remove buttons but instead a little plus with a circle around it, or a minus for an existing entry, that I couldn't find till my mouse hovered over it.

[kernel-panic69]

Use the dark themes in the firmware, problem solved. Forced dark modes don't work very well. The internal Firefox dark theme doesn't seem to have this issue that I recall.

P.S. You should also use a separate browser than what you surf the internet with. If you want to know why, I can show you unless you are behind CGNAT.

[mono]

[kernel-panic69]

Nope.