Posted: Thu Feb 27, 2025 15:08 Post subject: New Build - 02/27/2025 - r59887
Welcome to Atheros r59887 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp) 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Debug Analyze: stracetcpdump.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Posted: Thu Feb 27, 2025 15:39 Post subject: Linksys MR7350
Update method: WebUpgrade
Router/Version: Linksys MR7350
File/Kernel: 59887 / Linux 6.6.79-rt29 #2694 SMP Thu Feb 27 15:28:20 +07 2025 aarch64
Previous/Reset: 59661 / no
Mode/Status: Gateway / ok
Issues/Errors: If you are seeing this post, all is ok
Thank you again BS and friends.
�
Joined: 07 Jan 2025 Posts: 279 Location: Bethel Park, PA, USA
Posted: Thu Feb 27, 2025 18:45 Post subject:
Router/Version: Linksys MR7350 x 3
File/Kernel: DD-WRT v3.0-r59887 std (02/27/25), Linux 6.6.79-rt29 #2694 SMP Thu Feb 27 15:28:20 +07 2025 aarch64
Previous/Reset: DD-WRT v3.0-r59887 std (02/27/25), last reset on 58785
Mode/Status: Gateway (NSS-ECM-SFE), Access Point (5GHZ AC/N mixed, WPA2/WPA3, 802.11r/v/k, guest network, domain:PANAMA), performance governor, IPV6 (DHCP6 w/ prefix delegation), Entware, DOT via SmartDNS/DNSMasq, OpenVPN server, Wireguard Server + 2 Wired access points (DD-WRT firmware, 2.4GHz, 5GHZ, WPA2/WPA3, 802.11r/v/k, guest network, domain:PANAMA)
Issues/Errors:
Up 3 hours. USB 3.2 stick working properly for Entware and "jffs" partitions. Speed (tested via nPerf.com) is very close to published, which is equal or favorable to the ISP router. Wireguard and OpenVPN servers both working as expected and throughput sufficient to open video files on network shares. 5GHz showing 26dBm (set to 30dBm). 2.4GHz showing 28dBm (also set to 30dBm).
So far, the 2.4GHz has held steady at 28dBm.
Thank you Brainslayer. _________________ Formerly dpp3530 Linksys MX4300
Gateway, 2 wired APs, NSS-ECM , Clock 1651MHz
VAPs on wlan0 and wlan1 for guest/IOT devices
IPv4 & IPv6 (Prefix Delegation)
Static Leases & DHCP
SmartDNS (DOQ using NextDNS, Cloudflare), DNSMasq
Wireguard and OpenVPN server
2.4GHz: dd-wrt, AX Only, ACK Timing 2000, WPA3 SAE & WPA2 w/AES
5GHz: dd-wrt, AX/AC/N Mixed, ACK Timing 2000, WPA3 SAE & WPA2 w/AES
Verizon Fios, 500/500Mbps
Joined: 03 Nov 2015 Posts: 386 Location: Florida, USA
Posted: Thu Feb 27, 2025 21:03 Post subject:
Router: Linksys ea8500 ... WDS Station
Firmware: DD-WRT v3.0-r59887 std (02/27/25)
Kernel: Linux 6.1.129-rt28 #531 SMP Sat Feb 22 19:52:15 +07 2025 armv7l
Reset: NO ... GUI upgrade from r59171
Mode: 2.4 GHz only .. Firmware type VANILLA ..SFE Disabled
Errors: NONE so far...
****** Fast upgrade from r59171, the last build that has worked with WDS Vap. This build came right back with an AP/internet connection. Will try this Station on it for a while before I upgrade the others. Thanks ! BS and Gurus. Been an issue for a while but looks good for now ! _________________ ......All GOOD here... Just Handshakes and Time Stamps !......
Update method: CLI / SSH flash from konsole over wireless
Router: Linksys MX4200 v1
Firmware: DD-WRT v3.0-r59887 std (02/27/25) File: dd-wrt-webflash.bin
Kernel: Linux 6.6.79-rt29 #2696 SMP Thu Feb 27 17:00:38 +07 2025 aarch64
Previous/Reset: DD-WRT v3.0-r59820 std (02/23/25) / No
general - all settings default unless otherwise stated, USB disabled, telnet disabled, web access HTTPS only
general wireless- domain Panama, max TX power 22dBm all radios, WPA3 AES all wireless interfaces
setup - WAN to ONT, Gateway, AP, PPPOE, ignore WAN DNS, NSS-ECM, non-default router IP
ddns - SSL/TLS, force update interval 1
dnsmasq - encrypt DNS, quad9, DNSSEC, check unsigned DNS replies, no DNS rebind enabled, RFC4039 enabled
wlan0 - 5GHz, AC-only, VHT80
wlan1 - 2.4GHz, N-only, HT40
wlan1.1 - 2.4GHz guest network, unbridged, AP isolation, net isolation, DHCPD, web UI disabled
wlan2 - 5GHz, AX-only, HE80
ssh - non-default port, public key, password login disabled
wireguard server - non-default port, preshared key
Status: Stable
Issues/Errors: Radius is disabled on Services tab, but radius status shows as AP instead of disabled on Sys Info tab. Screenshots posted in 59764/5 build thread.
Linksys EA8500 ...main gateway
DD-WRT v3.0-r59887 std (02/27/25)
Linux 6.1.129-rt28 #531 SMP Sat Feb 22 19:52:15 +07 2025 armv7l
GUI install over r59661
waited few minutes after install --- silly thang didn't come back so I had to look and stupid top Linksys light was flashing.
I done a quick power off/on and she seems all fine now.
NOT reset in long long time...
samba all good
OVPN server worky real good.
just up 'bout 20 minutes ...hope good as r59661 -- had over 16 days with it
|
EDIT:
looky good so far 'r59887_dmesg'
isolated 2.4 VAP via br1 on EA8500 still worky good.
It's all good for me ...just some minor whatever doing GUI install
the specific config that doesnt work is when the VAP (not isolate) is on the 5GHz int which is also the STA and the router is a 7800. this was fixed in the past and broke again after 57793, i should also mention VHT80 Channel 149
Anyone test 802.11s on 5ghz? I know it’s been broken on the last two releases.
I am running a slightly newer internal release (which works), but I am pretty sure 802.11s should be working with this release as well. _________________ - Linksys EA8500: I-Gateway, WAP/VAP 5ghz only. Features: VLANs, Samba, WG, Entware - r60xxx
- Linksys EA8500: 802.11s Secondary w/VLAN Trunk over 5ghz - r60xxx
- Linksys MX4300: 802.11s Primary w/VLAN Trunk over 5ghz. 2.4ghz WAP/VAP only - r60xxx
- Linksys MX4300: (WAP/VAP (7)) Multiple VLANs over single trunk port. Entware/Samba r60xxx
- Linksys MR7350: WDS Station for extended Ethernet r60xxx
- Linksys MR7500, MX8500: None in production. Just testing. r60xxx
- OSes: Fedora 40, 10 RPis (2,3,4,5), 23 ESP8266s: Straight from Amiga to Linux in '95, never having owned a Windows PC.
- Forum member #248
