[SOLVED - hardware prob] MR7350-dropped 2.4GHz

Post new topic   Reply to topic    DD-WRT Forum Index -> Qualcomm Atheros based Hardware
Author Message
gitto
DD-WRT User


Joined: 05 Dec 2024
Posts: 102

PostPosted: Tue Dec 10, 2024 0:20    Post subject: [SOLVED - hardware prob] MR7350-dropped 2.4GHz Reply with quote
Hi,
This is a recently purchased 2nd hand router.
Problem is that only the 5Ghz seems to work now and can only have 2 AP. Any more than that, then no wifi works. Cable ok though.
That happens with 58785 (5th December) and 58753 (3rd December).
It was all working perfectly for a couple days. Don't know when the 2.4 (WLAN1) dropped.
Not completely convinced it isn't a hardware problem as the temperature sensors are all over the place. In the Status tab, at one point it was showing -255C for WLAN0 (now back to 50C). It is chilly, but not that chilly.
It is still showing 0C for WLAN1 though.
In Status / Wireless, under WLAN1, it says Radio Status Active, but WLAN1.1, 1.2 say Radio Status Unknown.

Have got another MR7350 coming though so will confirm in a few days.
Any other ideas welcome.


Last edited by gitto on Mon Dec 16, 2024 10:28; edited 1 time in total
Sponsor
gitto
DD-WRT User


Joined: 05 Dec 2024
Posts: 102

PostPosted: Fri Dec 13, 2024 15:00    Post subject: Reply with quote
Just an update.
Replacement MR7350 arrived.
Loaded up the same configuration from backup. All working now.
So, I got a device with a dodgy 2.4Ghz chip.

All good - I hope, unless the replacement one goes after 2 days. In that case there is a problem with the config.
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Qualcomm Atheros based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum