[Nuwrage]

Hi All! So I have an old E3000 that I attempted to flash dd-wrt on, and while it went well initially, upgrading to a newer version seems to have caused some issues. The router starts up and I can connect to it and the GUI however after a few minutes it suddenly doesn't work (the page is not reachable). After restarting it works again, but just for a few minutes. What can I do here? I guess I may have installed a version of dd-wrt that is a bit too big/causing memory issues? I don't believe the router itself is "bricked" as I can ping it even when the GUI is not accessible. Thanks!

Firmware version: DD-WRT v3.0-r56326 big (05/10/24)
Kernel version: Linux 2.6.24.111 #35579 Fri May 10 03:31:26 +07 2024 mips

[ho1Aetoo]

Your IP address will probably be blocked because you or your browser are fooling around

Connect to the router with another client with a different IP address and you will see that the web interface is accessible again

[bushant]

Forum Guide Lines (with helpful pointers about how to research your router, where and what firmware to download, where and how to post and many other helpful tips!)

Did you consult the wiki about what to flash?

https://wiki.dd-wrt.com/wiki/index.php/Linksys_E3000

[Nuwrage]

[kernel-panic69]

Private/Incognito browsing mode, no extensions or password managers utilized, preferably a portable browser that is not defaulting to https separate from your internet surfing. IDGAF what the YouTube videos show, just stop.