OpenVPN MTU-value is wrong on VPN-Server br0 and on tap1/2

Post new topic   Reply to topic    DD-WRT Forum Index -> Advanced Networking
Author Message
Sp1derman
DD-WRT User


Joined: 16 Jun 2006
Posts: 224
Location: Germany, BW

PostPosted: Wed Jul 17, 2024 12:45    Post subject: OpenVPN MTU-value is wrong on VPN-Server br0 and on tap1/2 Reply with quote
2x X64, 2 x build 55615, OVPN Bridge, OVPN version 2.6.10

I had to adjust the VPN-Tunnel MTU to 1420 as I suddenly got fragment Errors (EMSGSIZE...)
I noticed that on Client side br0 and tap1 got the same MTU value as Tunnel-MTU, but on server side br0 and tap2 are still at MTU 1500.

I change the values on server by hand, but after rebooting server br0 was still at MTU 1420 but tap2 was back to 1500. So I then changed back br0 to 1500.
I'm wondering if this the correct behaviour on server side, but I assume br0 and tap on server also should get the Tunnel-MTU value.

Any ideas?

EDIT:
After doing some more research I'm pretty sure.
On VPN-Server the MTU of br0 and the tun/tap device has to have the value of the tunnel-MTU.
This might cause some more trouble with the never ending VPN-MTU issue.
Sponsor
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Advanced Networking All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum