Posted: Tue Jan 02, 2024 15:42 Post subject: New Build - 01/02/2024 - r54682
Welcome to Marvell r54682 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp) 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Debug Analyze: stracetcpdump.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Explain, please. All the links in the OP point to the correct folder. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio
I couldn't upgrade to r54682, the "Wireless Interface wlan0 [5 GHz/802.11a]" clients didn't want to connect at all. I performed a factory reset and during the recovery process found that the chains "TX\RX Antenna Chains 1+2+3+4 " broken, only "1+2" are available. _________________ Linksys WRT1900ACSv2
Automatically adjustable temperature, always within the range of 59-68°С.
@Zyxx:
What kind of router do you have? In my WRT1900ACSv2, it was never possible to get a VHT 160, only a VHT80.
And do the settings you listed have a connection with the availability of "TX\RX Antenna Chains 1+2+3+4 "? - I don't think so.
I reset the settings to factory settings and did not find an opportunity to install "1+2+3+4". _________________ Linksys WRT1900ACSv2
Automatically adjustable temperature, always within the range of 59-68°С.
please forget my above post.
Years ago I switched my 1900acsv2 with a r7800.
The data I mentioned above was for the r7800, the WRT1900acs v2 is currently only in charge for ksmbd, wireguard and ADSL connection through modem, its WiFi is disabled.
Sorry for the inconvenience, need to drink more coffee in the morning
Will edit my above post.
Disable SFE. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio