Posted: Tue Mar 21, 2023 10:46 Post subject: New Build - 03/21/2023 - r52081
Welcome to Marvell r52081 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
List router model & version or revision, operating & wireless modes & exact filename/firmware image flashed.
CLI Flash: 'cd /tmp' then 'wget {file URL}' (httponly) or 'curl -O {file URL}' (http, https, ftp). 'write {file} linux' then 'reboot'.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Router Model Linksys WRT1900ACS v2
Firmware Version DD-WRT v3.0-r52081 std (03/21/23)
Kernel Version Linux 4.9.337 #3699 SMP Tue Mar 21 06:54:16 +07 2023 armv7l
Current Time Wed, 22 Mar 2023 08:12:38
Uptime 7:28
update-browser waterfox, I switched from partition one on the linksys firmware, all ok
connection Type PPPoE - IPv6 Type DHCPv6 with Prefix Delegation 1Gbps
IPv6 Type DHCPv6 with Prefix Delegation-On - Ok
Operating Mode Gateway/AP
Shortcut Forwarding Engine-On
Schedule Reboot-On,
Web Access Protocol - HTTPS,
SSH (public key)-ok
Encrypt DNS Enable
DNSCrypt Resolver-adguard-dns-family-ipv6
Validate DNS Replies (DNSSEC)-ok
Port Forwarding - Ok,
USB - System Log -Ok
Schedule Reboot - At a Set Time - On
After configuring the settings, I rebooted the router every time!
Wireless Interface 5GHz-Wireless Mode AP-Wireless Network Mode-AC, Width VHT 80 Mhz-Wireless Channel-36,Extension Channel LL, Short GI, Short Preamble, Single User Beamforming, Radio Scheduling, 30TX Power-23dBm ,TX Antenna Chains-1, RX Antenna Chains-1, Enable-WPA2 Personal-CCMP-128 (AES), Regulatory Domain Romania, all-ok
Router/Version: Asus RT-N66U
File: dd-wrt.v24-52081_NEWD-2_K3.x-big-RT-N66U.trx
Firmware: DD-WRT v3.0-r52081 big (03/21/23)
Kernel: Linux 4.4.302-st38 #22492 Tue Mar 21 08:25:13 +06 2023 mips
Mode: Gateway, SFE disabled, Wifi disabled, WAN disabled, Wireguard Endpoint for external VPS, connected via LAN to WRT1900ACS v2, Keep Alive reboot 6:05 in the morning
Reset: No
Status: Installed yesterday, OK.
Linksys WRT1900ACS
Firmware Version: DD-WRT v3.0-r52081 std (03/21/23)
Kernel: Linux 4.9.337 #3699 SMP Tue Mar 21 06:54:16 +07 2023 armv7l
It works on wired and 2 Wifi frequences. Upgrade from r52054 without reset.
I wonder after r52000, unbound has something leaking.
What I defined in /jffs/etc/unbound.conf, only forward-addr:78.46.244.143@853#dot-de.blahdns.com.
But result of https://www.dnsleaktest.com checking are:
188.122.68.218 hosted-by.i3d.net. i3D.net B.V Frankfurt am Main, Germany
188.122.68.219 hosted-by.i3d.net. i3D.net B.V Frankfurt am Main, Germany
66.185.117.242 res100.vie.rrdns.pch.net. WoodyNet Austria
66.185.117.243 res200.vie.rrdns.pch.net. WoodyNet Austria
66.185.117.244 res300.vie.rrdns.pch.net. WoodyNet Austria
66.185.117.251 res101.vie.rrdns.pch.net. WoodyNet Austria
66.185.117.252 res201.vie.rrdns.pch.net. WoodyNet Austria
Is it right? I remember that it never happen before r52000.