Posted: Sat Dec 31, 2022 10:47 Post subject: New Build - 12/31/2022 - r51140
Welcome to Broadcom r51140 beta release thread for reporting, feedback to developers & community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• WDS does not work on Broadcom ARM devices (only MIPS<->MIPS) & bridge modes on k4.4 devices may sometimes work
in some configurations for certain builds but are not supported by the bcmdhd driver. Try station or repeater mode but YMMV.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Joined: 01 Dec 2021 Posts: 289 Location: Maryland, United States
Posted: Sat Dec 31, 2022 12:24 Post subject:
Router/Version: Netgear R7000P
Firmware Version: DD-WRT v3.0-r51140 std (12/31/22)
Kernel Version: Linux 4.4.302-st28 #8436 SMP Sat Dec 31 04:25:18 +06 2022 armv7l
Previous/Reset: r51043 / No Reset
Mode/Status: Gateway / Working
Issues/Errors: Network adapter needed to e reset after firmware update due to very slow upload speeds (Verizon FiOS). Excellent performance using SFE with extremely low Ping times.
Joined: 18 Mar 2014 Posts: 12917 Location: Netherlands
Posted: Sat Dec 31, 2022 14:47 Post subject:
Router Model: Linksys EA6900 (XVortex CFE)
Firmware Version: DD-WRT v3.0-r51140M Community Build (12/31/22)
Kernel Version: Linux 4.4.302-st28 #1 SMP Sat Dec 31 12:17:13 CET 2022 armv7l
Upgraded DD-WRT v3.0-r51032M Community Build (12/15/22) via telnet (update via GUI not possible because nvram is placed on linux partition and not linux2 partition due to Xvortex CFE)
Reset: No not this time.
Configuration: Default gateway mode, 2,4GHz wireless running with unbridged VAP, 5GHz running, some static leases and some port range forwarding.
WireGuard client running with PBR.
OpenVPN client with PBR running.
NVRAM size 47K (NVRAM size should not be a problem with the Xvortex CFE)
Joined: 24 Feb 2013 Posts: 1634 Location: Belgrade
Posted: Sat Dec 31, 2022 16:35 Post subject:
Router/Version: Netgear R6250
File/Kernel: DD-WRT v3.0-r51140M Community Build (12/31/22) / Linux 4.4.302-st28 #1 SMP Sat Dec 31 15:31:17 CET 2022 armv7l
Previous/Reset: No
Mode/Status: Working great, ip6tun to Hurricane Electric, radvd, wifi Station bridge, Avahi, SFE, mactelnet
Issues/Errors: None
Router/Version: Netgear R8000 (brcmfmac)
File/Kernel: DD-WRT v3.0-r51140 std (12/31/22) / Linux 4.4.302-st28 #8439 SMP Sat Dec 31 05:00:48 +06 2022 armv7l
Previous/Reset: No
Mode/Status: Working, Avahi, wifi all tri bands, ipv6 PD, WG Server, dnsmasq with RA, CTF enabled...
Thank you Egc and BS
Issues/Errors: None
Posted: Sat Dec 31, 2022 20:37 Post subject: Netgear Nighthawk R7000
Router/Version: Netgear R7000 Firmware: DD-WRT v3.0-r51140 std (12/31/22) Kernel: Linux 4.4.302-st28 #8430 SMP Sat Dec 31 03:40:23 +06 2022 armv7l Mode: Gateway, Wireless AP, Static Leases, Dnsmasq Caching. CTF & FA Enabled. NAT and QOS Off. All services off under Status>Sys-info. Reset: Nope, ran remove unused NVRAM parameters script. Previous: 12-19-2022-r51043 Status: Working so far, still testing. 5.8Ghz power output low, 4.8Ghz good. Low 5.8Ghz throughput. Doesn't maintain higher link speeds. wl: 14E4:4360 Temperatures: CPU 56.9 °C / WL0 49.5 °C / WL1 50.6 °C Base CFE: Modified Asus ASUS RT-AC68P/ASUS RT-AC68U (C0 Model CFE V1.3.0.7) Configured as a stock R7000.
Speedtest-1.jpg
Description:
Speedtest Over 5.8GHz Wireless. ISP Spec: 400 Mbps Down / 25 Mbps Up.
Posted: Sun Jan 01, 2023 17:23 Post subject: ASUS RT-AC68U & 2 x Linksys E2000
Asus RT-AC68U
Firmware:DD-WRT v3.0-r51140 std (12/31/22) - (previous R51043)
Kernel: Linux 4.4.302-st28 #8430 SMP Sat Dec 31 03:40:23 +06 2022 armv7l
5Ghz (Mixed) with 80Mhz channel width: Ok
SSH: Ok
Telnet: Disabled
Site Survey: Ok
Wi-viz Survey 2.4Ghz & 5Ghz: Ok
Reset: No
Status: Ok
Uptime: 11 min
CPU Temperature: CPU 68.6 °C / WL0 46.5 °C / WL1 44.5 °C
2 x E2000
Firmware: DD-WRT v3.0-r51140 mega (12/31/22) - (previous r51043)
Kernel: Linux 4.4.302-st28 #20656 Sat Dec 31 05:40:24 +06 2022 mips
2.4Ghz (NG-mixed) with 40Mhz channel width: Ok
SSH: Ok
Telnet: Disabled
Site Survey: Ok
Wi-viz Survey 2.4Ghz: Ok
Reset: No
Status: Ok
Uptime: 23 min (the other a few minutes less)
CPU Temperature: WL0 53.0 °C / WL0 53.2 °C
All devices working as AP's each with individual 1Gb wired connections to main firewalls
No issues so far, will update if experiencing any.
Joined: 18 Mar 2014 Posts: 12917 Location: Netherlands
Posted: Mon Jan 02, 2023 11:50 Post subject:
Router Model: Netgear R6400v2, board_id: U12H332T
Firmware Version: DD-WRT v3.0-r51140M Community Build (01/01/23)
Kernel Version: Linux 4.4.302-st28 #1 SMP Sun Jan 1 11:41:04 CET 2023 armv7l
Upgraded from: DD-WRT v3.0-r50967M Community Build (11/28/22)
Reset: No not this time
Status: Up and running for 24 hours, basic setup as Gateway, static leases, 2,4GHz and 5Ghz working, USB storage NAS working. IPv6 (experimental new firewall from Mile-Lile) working.
OpenVPN server working.
WireGuard server (also with IPv6) working with 8 clients (phones, Windows and two other routers for site-to-site setup).
mDNS/Avahi working.
HOME Wired Multicast ISP 4K TV Network Router/Version: R7000
File/Kernel: DD-WRT v3.0-r51140 std (12/31/22)
Kernel Version: Linux 4.4.302-st28 #8430 SMP Sat Dec 31 03:40:23 +06 2022 armv7l
Previous/Reset: r51032 Router Swap Backup / CLI Update-> nvram erase-> reboot-> Maunal Re-configure
Mode/Status: GW / Working Well
Issues/Errors: none / none
Services Used: Multicast,IGMP,CTF,SSH,Syslog
Services Disabled: 2.4 & 5Ghz Radios,FA,QoS,ttraff,Telnet,NAS,Samba
Running for over 78 hours.
OffSite #1 Router/Version: R7000
File/Kernel: DD-WRT v3.0-r51140 std (12/31/22)
Kernel Version: Linux 4.4.302-st28 #8430 SMP Sat Dec 31 03:40:23 +06 2022 armv7l
Previous/Reset: r51032 Router Swap Backup / CLI Update-> nvram erase-> reboot-> Maunal Re-configure
Mode/Status: GW & AP / Working Well
Issues/Errors: none / none
Services Used: 2.4 & 5Ghz Radios,CTF,DHCP WAN,IPv6-6to4,NTP,WG Client,VLANx,BRx,SSH,Syslog,Cron,USB Storage,Entware DNSCrypt v2.1.1
Services Disabled: FA,QoS,ttraff,Telnet,NAS.Samba,YAMon3.4.6
Running for over 64 hours.
Thank-you & Happt New Year BrianSlyer for your Great Work and everyone else who makes DD-WRT Great on the Forum! _________________ Home Network on Telus 1Gb PureFibre - 10GbE Copper Backbone
2x R7800 - Gateway & WiFi & 3xWireGuard - DDWRT r53562 Std k4.9
Off Site 1
R7000 - Gateway & WiFi & WireGuard - DDWRT r54517 Std
E3000 - Station Bridge - DDWRT r49626 Mega K4.4
Off Site 2
R7000 - Gateway & WiFi - DDWRT r54517 Std
E2000 - Wired ISP IPTV PVR Blocker - DDWRT r35531
OffSite #2 Router/Version: R7000
File/Kernel: DD-WRT v3.0-r51140 std (12/31/22)
Kernel Version: Linux 4.4.302-st28 #8430 SMP Sat Dec 31 03:40:23 +06 2022 armv7l
Previous/Reset: r51032 Router Swap Backup / CLI Update-> nvram erase-> reboot-> Maunal Re-configure
Mode/Status: GW & AP / Working Well
Issues/Errors: none / none
Services Used: 2.4 & 5Ghz Radios,CTF,DHCP,WAN,IPv6-6to4,NTP,VLANx,BRx,SSH,Syslog,Cron,USB Storage,Entware DNSCrypt v2.1.1
Services Disabled: FA,QoS,ttraff,Telnet,NAS.Samba,YAMon3.4.6
Running for over 16 hours.
Thank-you & Happy New Year BrianSlyer for your Great Work and everyone else who makes DD-WRT Great on the Forum! _________________ Home Network on Telus 1Gb PureFibre - 10GbE Copper Backbone
2x R7800 - Gateway & WiFi & 3xWireGuard - DDWRT r53562 Std k4.9
Off Site 1
R7000 - Gateway & WiFi & WireGuard - DDWRT r54517 Std
E3000 - Station Bridge - DDWRT r49626 Mega K4.4
Off Site 2
R7000 - Gateway & WiFi - DDWRT r54517 Std
E2000 - Wired ISP IPTV PVR Blocker - DDWRT r35531