Posted: Mon Nov 28, 2022 10:25 Post subject: New Build - 11/28/2022 - r50963
Welcome to Atheros r50963 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
Linksys EA8500...main gateway
DD-WRT v3.0-r50963 std (11/28/22)
Linux 4.9.334 #1375 SMP Mon Nov 28 03:29:17 +07 2022 armv7l
scp 'firmware.bin' install over r50927
all good
#
Netgear WNDR3700 V4
DD-WRT v3.0-r50963 std (11/28/22)
Linux 3.18.140-d6 #158652 Mon Nov 28 09:01:14 +06 2022 mips
scp 'firmware.bin' install over r50927
all good
May I ask for a little piece of help about In-a-dyn version 2.9.1 and freedns.afraid.org . I think since r50841 I'm getting errors on dns update as follows:
In-a-dyn version 2.9.1 -- Dynamic DNS update client.
alias hnxxxx.mooo.com,eWMxxxxxTzNJxxxxxxdqdHVxxxxxxTRFOjExxxxxxzEy length 60
Failed resolving hostname hnxxxx.mooo.com,eWMxxxxxTzNJxxxxxxdqdHVxxxxxxTRFOjExxxxxxzEy: Name does not resolve
Update forced for alias hnxxxx.mooo.com,eWMxxxxxTzNJxxxxxxdqdHVxxxxxxTRFOjExxxxxxzEy, new IP# xx.x6.xx9.xx5
=> ERROR: Could not authenticate.
Both names hnxxxx.mooo.com and freedns.afraid.org are resolved though through the same router and even while connected to the router console via telnet or ssh. Perhaps In-a-dyn 2.9.1 needs slightly different syntax for afraid.org!?
I want to apologize if the topic is wrong, but I did a lot of search so far, unfortunately with no helpful result.
May I ask for a little piece of help about In-a-dyn version 2.9.1 and freedns.afraid.org . I think since r50841 I'm getting errors on dns update as follows:
In-a-dyn version 2.9.1 -- Dynamic DNS update client.
alias hnxxxx.mooo.com,eWMxxxxxTzNJxxxxxxdqdHVxxxxxxTRFOjExxxxxxzEy length 60
Failed resolving hostname hnxxxx.mooo.com,eWMxxxxxTzNJxxxxxxdqdHVxxxxxxTRFOjExxxxxxzEy: Name does not resolve
Update forced for alias hnxxxx.mooo.com,eWMxxxxxTzNJxxxxxxdqdHVxxxxxxTRFOjExxxxxxzEy, new IP# xx.x6.xx9.xx5
=> ERROR: Could not authenticate.
Both names hnxxxx.mooo.com and freedns.afraid.org are resolved though through the same router and even while connected to the router console via telnet or ssh. Perhaps In-a-dyn 2.9.1 needs slightly different syntax for afraid.org!?
I want to apologize if the topic is wrong, but I did a lot of search so far, unfortunately with no helpful result.
Kind Regards and thank you in advance!
Use the same user/passwd used to access your acc't page & JUST hnxxxx.mooo.com for hostname. Works for me.
PS No issues. _________________ NetGear XR500 - FW Version: DD-WRT v3.0-r53915 std (11/07/23)
Linux 6.1.61 #42 SMP Mon Nov 6 07:30:13 +07 2023 armv7l
Updated from: DD-WRT v3.0-r53843 std (11/01/23) via GUI (FF), NO reset
Gateway: SmartDNS, DDNS (FreeDNS), QoS, IPv4 DHCP, Static leases
AP: 2.4GHz NG-Mixed 40MHz, 5GHz AC/N-Mixed 80MHz, WPA2 w/ AES, MAC filtering, Isolated Guest VAP on wlan1, Vanilla FW
Services: USB Storage, NAS, Samba
Storage: Samsung Portable SSD T7 Shield USB 3.2 2TB, /jffs, /opt, /data (all ext4)
Last edited by d00zah on Wed Nov 30, 2022 13:58; edited 1 time in total
Router/Version: Netgear R7800
File: dd-wrt-webupgrade.bin
Firmware: DD-WRT v3.0-r50963 std (11/28/22) (prev. DD-WRT v3.0-r50906 std (11/18/22))
Kernel: Linux 4.9.334 #1377 SMP Mon Nov 28 04:13:14 +07 2022 armv7l
Mode: Gateway, SFE disabled, 2.4G and 5G wifi, Wireguard for external access, WAN to 4G (DHCP Client), Keep Alive reboot 6:02 in the morning
Reset: No
Status: Installed a few hours ago, ok.
Joined: 16 Nov 2015 Posts: 6177 Location: UK, London, just across the river..
Posted: Tue Nov 29, 2022 11:15 Post subject:
Router Model Netgear R7800
Firmware Version DD-WRT v3.0-r50963 std (11/28/22)
Kernel Version Linux 4.9.334 #1377 SMP Mon Nov 28 04:13:14 +07 2022 armv7l
update: CLI r50927 > r50963
reset: NO
mode: Gateway
status: Operational 18h+
errors: Nothing new, yet...SSh works ok..i can see dns-forward-max=150 comes by default in dnsmasq..
Thanks BS, egc, joker and the others _________________ Atheros
TP-Link WR740Nv1 ---DD-WRT 53045 WAP
TP-Link WR1043NDv2 -DD-WRT 54248 Gateway/DoT,Forced DNS,AP Isolation,Ad-Block,Firewall,VPN,x1VLAN
TP-Link WR1043NDv2 -DD-WRT 54079 Gateway/DoT,Forced DNS,Ad-Block,Firewall,x4VLAN,VPN
TP-Link WR1043NDv2 -Gargoyle OS 1.15.x AP,DNS,QoS,Quotas
Qualcomm-Atheros
Netgear R7800 --DD-WRT 54248 Gateway/DoT,AD-Block,Forced DNS,AP&Net Isolation,x3VLAN,Firewall,Vanilla
Netgear R9000 --DD-WRT 54079 Gateway/DoT,AD-Block,AP Isolation,Firewall,Forced DNS,x2VLAN,Vanilla
Broadcom
Netgear R7000 --DD-WRT 54079 Gateway/SmartDNS/DoH,AD-Block,Firewall,Forced DNS,x3VLAN,VPN
NOT USING 5Ghz ANYWHERE
------------------------------------------------------
Stubby DNS over TLS I DNSCrypt v2 by mac913
