Status: Up and running for 1 day, basic setup as Gateway, static leases, port forwarding DDNS, WOL 2,4GHz, VAP for IoT, 5Ghz (Vanilla Firmware, Disabled Airtime),
On demand governor with minimum 800 MHz
Router/Version: TP-link 1043ND v2.1
File/Kernel: DD-WRT v3.0-r50551 std (10/19/22)
Previous/Reset: No
Mode/Status: Gateway
Issues/Errors: Manual VLAN swconfig configuration gets overwritten by choosing Save & Apply Settings in General->Networking section
Not sure whether this is a bug or a feature but issue is well described here:
You need to save the swconfig commands as firewall so they survice reboots and clicking apply, its not a bug, startup scripts only get ran at startup/firwall get run at startup and after firewall restarts which is what clicking apply does, it restarts a bunch of services including networking.
Router/Version: TP-link 1043ND v2.1
File/Kernel: DD-WRT v3.0-r50551 std (10/19/22)
Previous/Reset: No
Mode/Status: Gateway
Issues/Errors: Unable to login using SSH keys when Password Login is switched to Disabled. Moreover if I switch Password Login back to Enabled SSH login also doesn't work.
Checked nvram output and apparently authorized_keys has been trimmed to "ssh-rsa" only.
[EDIT]
I have checked grep output with more lines (-A 10) and it looks the key is there but it has some empty/new line characters added and thus not working properly.
I was able to make it work only when restoring dd-wrt config from backup