Posted: Sun Jul 24, 2022 16:52 Post subject: WRT1900ACv2 Setup page not loading...
Hello everyone,
A friend of mine forgot the password of ther Q87-WRT1900ACV2. Therefore, I had to reset it. However, after I have performed the reset procedure the router local web page is not loading properly. Thus, I don't have options to continue with the setup and to finish it.
Please find pictures down below.
Any help is appreciated, because I am not quite sure, what else can be done.
Joined: 31 Jul 2021 Posts: 2146 Location: All over YOUR webs
Posted: Sun Jul 24, 2022 17:05 Post subject:
That sadly has nothing todo with DD-WRT
I suggest you consult your routers manufacturer documentation on how to reset the device.
The error is clear, the page you are trying to call doesn't exist, try to call the direct IP or some URL that goes up to the address not including the port portion.
You can try clearing Chrome's cache / CTRL+F5 / CTRL+SHIFT+R. _________________ "The woods are lovely, dark and deep,
But I have promises to keep,
And miles to go before I sleep,
And miles to go before I sleep." - Robert Frost
"I am one of the noticeable ones - notice me" - Dale Frances McKenzie Bozzio
The first thing to check is the Model No. listed on the bottom of the router in the upper-right corner.
"Q87-WRT1900ACV2" is FCC ID, do not rely on it for accurate information so check Model No. only.
Wonder why? WRT1900AC V2, WRT1900ACS V1 and WRT1900ACS V2 all three have same FCC ID!
There are four hardware models, revisions or variants of WRT1900AC series all different firmwares.
Hardware reset is hold reset button 10 seconds... WRT1900AC V1 and V2, WRT1900ACS V1 and V2
If DD-WRT is correctly installed and the boot partition switched to stock firmware, just switch again.
Switching back in Linksys WebUI: see Troubleshooting, Diagnostics then Restore Previous Firmware.