Posted: Sun Jul 10, 2022 16:34 Post subject: New Build - 07/09/2022 - r49467
Welcome to Marvell r49467 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, SB, WDS, Mesh) and applicable configurations to reproduce.
after update i notice that the Lan connection was lost after some time. the connection lost for e.g.10sec. ! This fault comes up again in a cycle!
This must be a new fault, I never had this fault on Lan before.
Info:
for WLan i use UniFi AP AC LITE as access Point! Also the Lan connection to the access point is lost in case of this error!
I go back to the version r49392 !
The Version r49392 work ok, Lan connection was stable
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
can someone confirm this issue ?
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
best regards
Last edited by Fritzbuf on Wed Jul 13, 2022 11:43; edited 3 times in total
Router/Version: Linksys WRT1900ACS v2
File: ddwrt-linksys-wrt1900acsv2-webflash.bin
Firmware: DD-WRT v3.0-r49467 std (07/09/22) (prev. DD-WRT v3.0-r49392 std (06/29/22))
Kernel: Linux 4.9.322 #3300 SMP Sat Jul 9 13:21:02 +07 2022 armv7l
Mode: Gateway, SFE enabled, Wifi disabled, Wireguard for external access, WAN to DSL, samba to access USB3-ext4 SSD, Keep Alive reboot 5:00 in the morning
Reset: No
Status: Up since release, ok. Load average 0.00, 0.00, 0.00, Temperatures CPU 77.4 °C / WL0 50.3 °C / WL1 52.0 °C