Posted: Fri Jun 10, 2022 9:21 Post subject: New Build - 06/10/2022 - r49139
Welcome to Marvell r49139 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• Detail issues & relevant configs, logs: syslog klog 'dmesg' 'cat /tmp/var/log/messages' nvram set console_debug=1, serial.
• Firewall NAT: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' & 'cat /tmp/.ipt'. Misc: stracetcpdumpwireshark.
• Gremlins: reboot. cold boot. Reset & reconfigure not restore backup. Search Trac & discuss in forum before opening tickets.
• Include operating & wireless modes (e.g. Gateway, Router, AP, CB, WDS, Mesh) and applicable configurations to reproduce.
DD-WRT Router Model Linksys WRT1900ACS v2
Firmware Version DD-WRT v3.0-r49139 (06/10/22)
Kernel Version Linux 4.9.317 #3262 SMP Fri Jun 10 13:36:20 +07 2022 armv7l
Uptime7:16
update- browser-waterfox,I switched directly from the first partition from the original software,
connection Type PPPoE - IPv6 Type DHCPv6 with Prefix Delegation-,No release on reconnect-on, Schedule Reboot-on
Port Forwarding ok
Wireless Interface 5GHz-Wireless Mode AP-Wireless Network Mode-AC, Width VHT 80 Mhz-Wireless Channel-36-Short GI, Short Preamble,Single User Beamforming, Radio Scheduling, Enable-WPA2 Personal-CCMP-128 (AES, Regulatory Domain Romania , all-ok
Wireless Interface 2.4GHz-Wireless Mode AP-Wireless Network Mode-N/G, Width VHT 40 Mhz-Wireless Channel-6, Extension Channel Lower,Short Preamble, Short GI , Radio Scheduling, Enable-WPA2 Personal-CCMP-128 (AES)all-ok _________________ Internet provider https://en.wikipedia.org/wiki/RCS_%26_RDS 1Gbps
WDR3600 rev.1.5 - DD-Wrt
Linksys WRT1900ACS v.2 DD-Wrt/-OpenWrt
EDIT (2022-06-16): I don't know the cause, but 5 GHz wifi was failing to broadcast about 2 out of every 3 reboots on the ACS v2. I didn't see any differences in the syslogs. The ACS v1 had no such issue despite very similar settings. 2.4 GHz was normal on both. I've just updated both to today's newer release. _________________ My DD-WRT Routers:
Linksys WRT3200ACM - Marvell
Linksys WRT1900ACS - Marvell
Netgear R9000 - Atheros
Netgear R7000 - Broadcom
PC x86-64 VM - Atheros
Last edited by o2bad455 on Thu Jun 16, 2022 20:03; edited 2 times in total
Router/Version: Linksys WRT1900ACS v2
File: ddwrt-linksys-wrt1900acsv2-webflash.bin
Firmware: DD-WRT v3.0-r49139 std (06/10/22) (prev. DD-WRT v3.0-r46380 std (04/17/21))
Kernel: Linux 4.9.317 #3262 SMP Fri Jun 10 13:36:20 +07 2022 armv7l
Mode: Gateway, SFE enabled, Wifi disabled, Wireguard for external access, WAN to DSL, Keep Alive reboot 5:00 in the morning
Reset: No
Status: Up since yesterday, ok. (After a 11 month hiatus - replacing my old trustworthy netgear r7000, until I had a closer look onto its hardware first). Load average 0.00, 0.00, 0.00, Temperatures CPU 75.5 °C / WL0 48.6 °C / WL1 50.3 °C