The router wasn't getting the wan ip via dhcp so after a few tentatives and supported by my headache i installed version
when restared and after the root passwd choice i was presented with an apply cgi error
The route is very very slow i can barely telnet it
no http running etc , it looks semi bricked but still accessible .. however no internet
Now what i can do to re-establsh a regular behavior ?
reinstall the best possible yet release via cli ?
should i get a wan ip via dhcp ?
can someone give me some directions .. ?
'ubootenv get boot_part' then 'ubootenv set boot_part 1' or 2, alternate value returned from get, 'reboot'
or
There is a triple power toggle failover method to force switch the boot partition.
It is a pain sometimes to find correct timing, so here are alternate descriptions.
Power ON and when LAN LED is blinking immediately turn it OFF then wait at least three seconds, repeat.
Then power it on a third time and let it run.
Another visual cue is power LED blinks a few times then turns off for about 2 seconds, switch power OFF.
which version is a known good for my router linksys wrt3200 acm ?
actually on my other router in my other home i have v 41218 sometime has to be rebooted but at least it gets dhcp ip from the wan modem and the openvpn stack is fully functional ...however is quite old 10/01/19
btw is there an alternative method to get connection with the wan ?
on my other wrt3200acm i fixd the ip giving as gateway the isp modem lan ip ...
then supposedly i forgot this was a common problem