I was able to access the gateway menu through the default gateway IP address. I went to sleep with the intent to finish setting it up this morning. However after turning it on this morning, I was unable to make a connection (Network Cable Unplugged, and I checked the Ethernet settings to ensure that my static IP address was properly configured).
Pinging it was of no use, nor 30/30/30ing or Hard Resetting. I'm a bit directionless and would appreciate some help.
In regards to the LEDs, they are not blinking and (seemingly) randomly switch between which are on whenever I turn on the router.
Thank you for responding to my thread kernel-panic69. I did take a look at the Peacock thread, but perhaps not as thoroughly as I should have.
I downloaded the resources from these links and used them for the conversion process:
-https://download1.dd-wrt.com/dd-wrtv2/downloads/others/eko/WRT54GS2V1%20Flashing/VxWorksKiller-GS2V1.bin
-https://download1.dd-wrt.com/dd-wrtv2/downloads/betas/2020/11-03-2020-r44715/broadcom/dd-wrt.v24_micro_generic.bin
I tried another reset / leaving it on for a while and it is still in the same state it was before (LEDs illuminate with no reaction / unable to ping / no Wi-Fi access point)