Joined: 08 May 2018 Posts: 14208 Location: Texas, USA
Posted: Wed Jan 12, 2022 0:42 Post subject:
No. What you need to do is upgrade to the most recent build with the webflash file in the current release directory... please read the linked information given. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
If you just skim through the reading material and start flashing a bunch of different firmware builds to this router, you MIGHT end up bricking your router. _________________ For people who are new to the dd-wrt forums >> http://www.catb.org/~esr/faqs/smart-questions.html#rtfm
barryware wrote:
It takes a "community" to raise a router..
Internet Connection 1
Some Techicolor modem > Linksys WRT3200ACM
Internet connection 2
Ubiquiti Powerbeam Gen 2 > Netgear R9000
Official (but not really) dd-wrt General Discussion element/matrix chat
[quote="kernel-panic69"]You did follow the upgrade instructions about knowing which partition was in use and what to set prior to upgrading, correct?[/quote]
No.
I´m starting again from 0.
Firmware Installed is: DD-WRT v3.0-r34315 std (12/30/17).
I don´t know in which partition of the nvram is.
Telnet is on.
Putty is running.
Router Reseted for 20 seconds.
And it Booted the DD-WRT firmware, so probably i installed it bad using the two partitions.
so:
telnet 192.168.1.1
root
admin
ubootenv get boot_part
a_Penv->crc = d69a62b6
crc32 = d69a62b6
1
So i´m on Partition 1
Now i don´t know how to continue.
Probably if i install a newer version from the dd-wrt GUI it will say again " upgrade failed"
Now i´m on the index , link provided by "Kernel-panic69"
Index of /dd-wrtv2/downloads/betas/2022/01-11-2022-r48081/linksys-wrt1900acs/
I think that i should download -
ddwrt-linksys-wrt1900acs-webflash.bin 11-Jan-2022 05:54 37490688
is that correct?
Last edited by macawcode on Tue Jan 18, 2022 2:08; edited 5 times in total
Check out the video above. May be helpful? Also, I'm no expert, but if you're starting again you may want to start with a firmware version newer than 2017? Seems pretty old to me. Good luck!
[quote="Oldsmobile_Mike"]Check out the video above. May be helpful? Also, I'm no expert, but if you're starting again you may want to start with a firmware version newer than 2017? Seems pretty old to me. Good luck![/quote]
Yes thanks for your video.
I started trying to update via linksys GUI,
with a lot of dd-wrt most recent versions,
I tried a lot of times but the router booted in linksys again and again.
Only with the Factory version Firmware: DD-WRT v3.0-r34315 std (12/30/17) the router booted in dd-wrt
