Posted: Thu Jan 06, 2022 8:14 Post subject: New Build - 01/06/2022 - r47976
Welcome to Atheros r47976 beta release thread for reporting, feedback to developers and community benefit.
Please do not flash builds until installation is understood, risks involved and device specificrecovery methods.
Avoid discussions, create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues, observations, and/or workarounds reported:
• WebUI: Clear history or use a portable. Temporary cache bypass: Ctrl+F5, Cmd+Shift+R or new private window/incognito.
• Please report findings with steps needed to reproduce, configuration, clients, output, logs and important information below!
Important:
• For issues provide applicable info: 'dmesg' 'cat /tmp/var/log/messages', syslog klog, serial, strace, tcpdump, wireshark etc.
• Any firewall NAT or WAN issues, show output: 'iptables -vnL' 'iptables -t nat -vnL' 'iptables -t mangle -vnL' and /tmp/.ipt file.
• Gremlins: reset & configure manually, not restore a backup. Reboot. Search Trac & discuss in forum before opening tickets.
• Please include operating & wireless modes (e.g. Gateway, Router, AP, CB, WDS, Mesh) & relevant configuration information.
Linksys EA8500...main gateway router
DD-WRT v3.0-r47976 std (01/06/22)
Linux 4.9.295 #639 SMP Thu Jan 6 02:22:58 +07 2022 armv7l
GUI install over r47961
all good
--
EDIT:
NO it IS NOT all good
samba shares ---> same screwed up crap like it was before
--
EDIT again:
last few lines of system log:
Code:
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2517]: INFO: File '/tmp/ksmbd.lock' belongs to pid 2468
Jan 6 02:22:56 EA8500 local5.err ksmbd: [ksmbd-manager/2517]: ERROR: Failed to create lock file: File exists
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2517]: INFO: Exiting. Bye!
Jan 6 02:22:56 EA8500 user.info : [smbd] : samba started
Jan 6 02:22:56 EA8500 user.info wsdd2[2545]: starting.
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2550]: INFO: File '/tmp/ksmbd.lock' belongs to pid 2468
Jan 6 02:22:56 EA8500 local5.err ksmbd: [ksmbd-manager/2550]: ERROR: Failed to create lock file: File exists
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2550]: INFO: Exiting. Bye!
Jan 6 02:22:56 EA8500 user.info wsdd2[2560]: starting.
Jan 6 02:22:56 EA8500 user.info : [smbd] : samba started
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2564]: INFO: File '/tmp/ksmbd.lock' belongs to pid 2468
Jan 6 02:22:56 EA8500 local5.err ksmbd: [ksmbd-manager/2564]: ERROR: Failed to create lock file: File exists
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2564]: INFO: Exiting. Bye!
Jan 6 02:41:56 EA8500 daemon.info httpd[1571]: [httpd] : Authentication fail
Jan 6 02:41:56 EA8500 daemon.err httpd[1571]: [httpd] : Request Error Code 401: Authorization required. Wrong username and/or password!
Jan 6 03:22:48 EA8500 daemon.debug ntpclient[2839]: Connecting to 2.pool.ntp.org [46.235.112.25] ...
Jan 6 03:22:48 EA8500 daemon.info ntpclient[2839]: Time set from 2.pool.ntp.org [46.235.112.25].
Jan 6 03:22:48 EA8500 daemon.info process_monitor[1972]: cyclic NTP Update success (servers 2.pool.ntp.org 212.18.3.19 88.99.174.22)
Jan 6 03:27:57 EA8500 authpriv.info dropbear[2864]: Child connection from 10.72.28.56:38282
Jan 6 03:27:58 EA8500 authpriv.notice dropbear[2864]: Pubkey auth succeeded for 'root' with key md5 02:dd:6e:8e:c8:bb:bc:e9:23:24:92:0d:ea:2c:7b:17 from 10.72.28.56:38282
root@EA8500:~#
NOT same as last time samba was screwed but tis a very bad ksmbd shit
#
Netgear WNDR3700 V4
DD-WRT v3.0-r47976 std (01/06/22)
Linux 3.18.140-d6 #133214 Thu Jan 6 07:36:46 +07 2022 mips
GUI install over r47961
switch / ovpn server
all ok
Update method: SSH / CLI
Router/Version: Netgear R9000 Nighthawk X10
File/Kernel: DD-WRT v3.0-r47976 std (01/06/22)
Previous/Reset: DD-WRT v3.0-r47942 std (12/30/21) / No
Mode/Status: Gateway / Working Normally
Issues/Errors: Although the build did load the leases file on reboot, and the Use JFFS2 for client lease DB option was checked, I had to click Apply on the page to get the dnsmasq.leases file to start updating on /jffs. _________________ Netgear R9000
DD-WRT v3.0-r55819 std (04/17/24)
Linux 4.9.337 #722 SMP Wed Apr 17 04:16:49 +07 2024 armv7l
Gateway, AP, DNSMasq, Clock 2000MHz
VAP on wlan1 for internet devices
IPv4 & IPv6 (Prefix Delegation)
Static Leases & DHCP
CloudFlare, no SFE, SmartDNS, no QoS
2.4GHz: Vanilla, Airtime Fairness, NG-Mixed, ACK Timing 3150, WPA2 w/AES & WPA3
5GHz: Vanilla, Airtime Fairness, AC/N Mixed, ACK Timing 3150, WPA2 w/AES & WPA3
2 Netgear AX1800 WiFi Mesh Extenders
Xfinity 1.2Gbps/35Mbps
Joined: 06 Jun 2006 Posts: 7492 Location: Dresden, Germany
Posted: Thu Jan 06, 2022 14:12 Post subject:
mrjcd wrote:
Linksys EA8500...main gateway router
DD-WRT v3.0-r47976 std (01/06/22)
Linux 4.9.295 #639 SMP Thu Jan 6 02:22:58 +07 2022 armv7l
GUI install over r47961
all good
--
EDIT:
NO it IS NOT all good
samba shares ---> same screwed up crap like it was before
--
EDIT again:
last few lines of system log:
Code:
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2517]: INFO: File '/tmp/ksmbd.lock' belongs to pid 2468
Jan 6 02:22:56 EA8500 local5.err ksmbd: [ksmbd-manager/2517]: ERROR: Failed to create lock file: File exists
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2517]: INFO: Exiting. Bye!
Jan 6 02:22:56 EA8500 user.info : [smbd] : samba started
Jan 6 02:22:56 EA8500 user.info wsdd2[2545]: starting.
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2550]: INFO: File '/tmp/ksmbd.lock' belongs to pid 2468
Jan 6 02:22:56 EA8500 local5.err ksmbd: [ksmbd-manager/2550]: ERROR: Failed to create lock file: File exists
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2550]: INFO: Exiting. Bye!
Jan 6 02:22:56 EA8500 user.info wsdd2[2560]: starting.
Jan 6 02:22:56 EA8500 user.info : [smbd] : samba started
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2564]: INFO: File '/tmp/ksmbd.lock' belongs to pid 2468
Jan 6 02:22:56 EA8500 local5.err ksmbd: [ksmbd-manager/2564]: ERROR: Failed to create lock file: File exists
Jan 6 02:22:56 EA8500 local5.info ksmbd: [ksmbd-manager/2564]: INFO: Exiting. Bye!
Jan 6 02:41:56 EA8500 daemon.info httpd[1571]: [httpd] : Authentication fail
Jan 6 02:41:56 EA8500 daemon.err httpd[1571]: [httpd] : Request Error Code 401: Authorization required. Wrong username and/or password!
Jan 6 03:22:48 EA8500 daemon.debug ntpclient[2839]: Connecting to 2.pool.ntp.org [46.235.112.25] ...
Jan 6 03:22:48 EA8500 daemon.info ntpclient[2839]: Time set from 2.pool.ntp.org [46.235.112.25].
Jan 6 03:22:48 EA8500 daemon.info process_monitor[1972]: cyclic NTP Update success (servers 2.pool.ntp.org 212.18.3.19 88.99.174.22)
Jan 6 03:27:57 EA8500 authpriv.info dropbear[2864]: Child connection from 10.72.28.56:38282
Jan 6 03:27:58 EA8500 authpriv.notice dropbear[2864]: Pubkey auth succeeded for 'root' with key md5 02:dd:6e:8e:c8:bb:bc:e9:23:24:92:0d:ea:2c:7b:17 from 10.72.28.56:38282
root@EA8500:~#
NOT same as last time samba was screwed but tis a very bad ksmbd shit
#
Netgear WNDR3700 V4
DD-WRT v3.0-r47976 std (01/06/22)
Linux 3.18.140-d6 #133214 Thu Jan 6 07:36:46 +07 2022 mips
GUI install over r47961
switch / ovpn server
all ok
so you are just complaining about log entries? i mean i can remove log messages. no big thing _________________ "So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s
alright then but I really got other things to do
r47942 works perfectly fine
AND
logs do NOT tell anything
had to boot back into r47976 just to do this
r47976 towards bottom of page---
https://mrjcd.com/junk/dd-wrt/EA8500/r47976_BadSamba.html
drives mount just fine
r47976 can NOT copy to the share drive at all ... I get this anytime I try to copy to it---
This is on the EA8500 used as ovpn server, switch, samba share.
Exact same crap on EA8500 main gateway ...and NO I am not messing with it anymore.
---
EDIT:
the very last bit of system log was after I tried to copy to its drive --- NO log change
---
better screenshot and this is try to copy to the other flash drive ...same shit