I got two DD-WRT flashed TP Link WR940N V.6 router and a GoPro Hero 4. The webinterface says its this version: DD-WRT v3.0-r47900 std (12/20/21). However, i flashed "12-20-2021-r47900".
The second router has added the gopro in client mode and i added the local ip adress to a different subnet 192.168.2.2 . DHCP is disabled.
On the main router in "advanced routing" in gateway operating mode i added to the routing table the LAN NET address of the gopro and the gateway adress 192.168.2.2. The router are conntected with LAN cable.
I cant access the gopro when wifi connected to the main router. Do you have an idea?
Joined: 18 Mar 2014 Posts: 12887 Location: Netherlands
Posted: Tue Dec 21, 2021 9:07 Post subject:
To give better support it helps if you also tell the buildnumber you are using.
See the forum guidelines with helpful pointers about how to research your router, where and what firmware to download, where and how to post and many other helpful tips:
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087
Assigning an ip address to the second router thats within the network of the local host (192.168.1.X) fixed it. It allows to generally access the gopro now. However, there were problems reported to access individual ports of the gopro to receive the livestream which i will check now.
ok after i did port forwarding on the second router i could also receive the udp livestream from the hololens when connected to the main router. The ip address that needs to be used for port forwarding is the one of the client within the main router network !
Joined: 13 Aug 2013 Posts: 6868 Location: Romerike, Norway
Posted: Fri Dec 24, 2021 11:16 Post subject: Re: Client for GoPro AP and AP for other devices
HoloLens111 wrote:
On the main router in "advanced routing" in gateway operating mode i added to the routing table the LAN NET address of the gopro and the gateway adress 192.168.2.2.
The static route will be 192.168.2.0/24 with 192.168.1.X as next hop. where X is the address of the second router.
with full routing, you do not need any portforwards.