Joined: 08 May 2018 Posts: 14125 Location: Texas, USA
Posted: Thu Sep 30, 2021 16:38 Post subject:
Did you set a static IP before flashing to something in the 192.168.0.x subnet? Did you try using the windows network troubleshooter? The ipconfig method doesn't always work in windows 10, 8.x, 7, or XP. This could be a case where that firmware image was too big or broken, as well. I am trying to back-track and see if I can't find information. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
unfortunately, i didnt set a static ip. nor used troubleshooter.
i found an instruction from the internet and followed it.
dd-wrt firmware was downloaded from this site, specific for my router, MR3220 v1.
Now when i turn on the router PWR light and lan port light (port that connected via lan cable to PC) blinks for milliseconds then all the lights blink, then turns off except PWR light. Then described cycle goes again. Is it even bricked?
Joined: 08 May 2018 Posts: 14125 Location: Texas, USA
Posted: Thu Sep 30, 2021 17:09 Post subject:
The trouble with 3rd party how-to's is they will steer you wrong. 44715 may be a bad initial flash for this router. But you should be able to recover this via tftp; worst case is you have to use a USB-TTL serial adapter and PuTTY to get it to tftp flash. _________________ "Life is but a fleeting moment, a vapor that vanishes quickly; All is vanity"
Contribute To DD-WRT Pogo - A minimal level of ability is expected and needed... DD-WRT Releases 2023 (PolitePol)
DD-WRT Releases 2023 (RSS Everything)
----------------------
Linux User #377467 counter.li.org / linuxcounter.net
Dear kernel-panic69
Could you please describe the whole process of recover via tftp? Please give the right links to programms needed. I am newbie to this things, all I can do is following instructions.