[Anoopnk]

I'm trying to get 2 tunnels working from the same VPN provider with PBR. Connection is established with both but fails to work. If only one of them is enabled, it works fine.

I am trying to use PBR to route 192.168.1.192/26 through oet1 and 192.168.1.128/26 through oet2. When I try to open a page, I see the counter increasing but internet doesn't work.

Thanks

P.S images attached, please login to view them

[egc]

Both tunnels have the same IP address that will not work.

For my provider I can get different IP addresses for different servers, research if that is possible for your provider too

[Anoopnk]

Where is this IP actually being used? I'm don't understand it much. I thought this IP is assigned for the interface in their servers. So having the same IP in different servers shouldn't matter since interface is used on router's end for routing.

I've raised a support ticket asking my provider if they can provide different IP for wg tunnels.

(Apologies for image size. In the preview, it looked all fine)

[egc]

It is the IP of your WireGuard interface and you end up with two interfaces with the same IP address

[Anoopnk]

Ah I see. That raises another question, why would my provider decide this IP? Why wouldn't it work if I set different IP?

For now, I'm using openVPN as my second tunnels. It was as easy as setting this up, in case anyone else wanted something similar.

[egc]

From our documentation (links in my signature):