Posted: Sun May 30, 2021 12:05 Post subject: New Build - 05/30/2021 - r46816
[WARNING]: This thread is only for feedback on this beta release for developers and the community's benefit.
DO NOT flash this beta release unless you understand the risks involved and device specificrecovery methods.
Avoid discussions! Create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Issues:
• Show us your findings with steps to reproduce, configuration, output, logs and important information below!
Important:
• For issues provide applicable info: 'dmesg', 'cat /tmp/var/log/messages', syslog, klog, serial, strace, tcpdump, wireshark etc.
• Any firewall NAT or WAN issues, show output: 'iptables -vnL', 'iptables -t nat -vnL', 'iptables -t mangle -vnL' and /tmp/.ipt file.
• Search SVN tickets & discuss in forum before opening. Before reporting: reset & manually set up, not restore from a backup.
• Please include operating & wireless modes (e.g. Gateway, Router, AP, CB, WDS, Mesh) & relevant configuration information.
Further burp approx 12 hrs later, without stack trace this time.
Quote:
Jun 1 13:30:06 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet eth0: port 1 link down
Jun 1 13:30:09 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet eth0: port 1 link up
Jun 1 13:44:55 eiger kern.err kernel: mtk_soc_eth 1e100000.ethernet eth0: transmit timed out
Jun 1 13:44:55 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet eth0: dma_cfg:80000065
Jun 1 13:44:55 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet eth0: tx_ring=0, base=059e0000, max=0, ctx=1910, dtx=1910, fdx=1909, next=1910
Jun 1 13:44:55 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet eth0: rx_ring=0, base=04480000, max=0, calc=3810, drx=3811
Jun 1 13:44:55 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet: 0x100 = 0x6060000c, 0x10c = 0x80818
Jun 1 13:44:55 eiger kern.info kernel: mtk_soc_eth 1e100000.ethernet: PPE started
Jun 1 14:26:12 eiger daemon.debug ntpclient[5183]: Connecting to uk.pool.ntp.org [162.159.200.1] ...
Jun 1 14:26:12 eiger daemon.info ntpclient[5183]: Time set from uk.pool.ntp.org [162.159.200.1].
I also note that port 1 seems to regularly go down and back up in short order. If port 1 is what is show in the Switch Config sub-tab, this links to an unmanaged switch that handles the lan side. That should be on all the time, as there always some traffic passing through it.
I wonder if that up and down is a symptom of what's wrong going wrong in the router....