Posted: Fri Jan 01, 2021 13:17 Post subject: New Build - 01/01/2021 - r45229
[WARNING]: This thread is only for feedback on this beta release for developers and the community's benefit.
DO NOT flash this beta release unless you understand the risks involved and specific device recovery methods.
Avoid discussions! Create threads for questions, general problems or use search; this thread is not for support.
Please list router model & revision, operating & wireless mode(s) and exact filename/firmware image flashed.
Notes:
• CVE-2019-14899 VPN fix (applicability depends on VPN setup) and GUI toggle. 6920, 6928, 6931, 6932 (WIP 7040)
• In-kernel Samba has been implemented this year and default min/max versions have changed 6954, 6957, with WSD support.
• VAP issue is fixed! For any Wireless Mode, create a VAP and both ath0/ath1 should now function properly.
• Local DNS option removed from Services->DNSMasq in changesets 43080 and 43081; ref: #7092
• DHCP and DNS help (English) updated in 43083; ref: #7091
• WireGuard 1.0.20200908 & Tools: PBR, Kill Switch, Inbound Firewall, Naming of Peers, Status, Key, Guides. Thanks BS & egc!
• OpenVPN Version 2.5.0
Issues:
• There may be remaining issues for Samba (for example NTFS), with frequent updates.
Important:
• If reporting issues provide applicable info: 'dmesg', 'cat /tmp/var/log/messages', syslog, serial output, strace, tcpdump etc.
• For firewall NAT or WAN issues provide 'iptables -vnL', 'iptables -t nat -vnL', 'iptables -t mangle -vnL' and the /tmp/.ipt file.
• Search existing SVN tickets before opening a new one. Before reporting, reset and manually setup (no nvram backup).
• Be sure to include operating and wireless modes (Gateway, AP, CB, etc.) along with relevant configuration information.
Update method: SSH
Router/Version: Netgear Nighthawk X10
File/Kernel: DD-WRT v3.0-r45229 std (01/01/21)
Previous/Reset: DD-WRT v3.0-r45223 std (12/31/20) / No
Mode/Status: Gateway / Working Normally
Issues/Errors: I still see occasional errors in the log like these:
Jan 1 13:05:45 LandiRouter daemon.err dnsmasq[2734]: failed to send packet: Network unreachable
Jan 1 13:08:20 LandiRouter daemon.err dnsmasq[2734]: failed to send packet: Address family not supported by protocol _________________ Netgear R9000
DD-WRT v3.0-r55819 std (04/17/24)
Linux 4.9.337 #722 SMP Wed Apr 17 04:16:49 +07 2024 armv7l
Gateway, AP, DNSMasq, Clock 2000MHz
VAP on wlan1 for internet devices
IPv4 & IPv6 (Prefix Delegation)
Static Leases & DHCP
CloudFlare, no SFE, SmartDNS, no QoS
2.4GHz: Vanilla, Airtime Fairness, NG-Mixed, ACK Timing 3150, WPA2 w/AES & WPA3
5GHz: Vanilla, Airtime Fairness, AC/N Mixed, ACK Timing 3150, WPA2 w/AES & WPA3
2 Netgear AX1800 WiFi Mesh Extenders
Xfinity 1.2Gbps/35Mbps
R7800
Updated via GUI
No reset
No issues after 30 minutes _________________ 2 R7800's (Kong OpenWRT 23.05) as access points
X86_64 build PC (DDWRT Build r55630)
3 R7000's (DDWRT build r53843)using one as a bridge currently
Netgear WNDR 3400 (DDWRT r55630)
Netgear DGND 3700 (with OpenWRT)
Router/Version: Linksys EA8500 / Box Rev.A00 PCB REV:205(XC) hw_rev=1 hw_ver=XB / r45229 (01/01/21)
File/Kernel: CLI Flash dd-wrt-webupgrade.bin / Linux 4.9.248 #970 SMP Thu Dec 31 23:05:52 +07 2020 armv7l
Previous/Reset: r45219 (12/31/20) / No
Mode/Status: AP Gateway
Issues/Errors: Web GUI Wireless -> Basic Settings - wlan1 basic settings are missing from the webGUI.
Can anyone advise how to get them back? _________________ Location (urban) - 1x Linksys EA8500 (AP wlan0 & wlan1 enabled)
1x Asus 68u (Repeater Bridge w/VAP) - wl0 disabled
1x Asus 87u (Client Bridge) - wl1 disabled
R7800
Updated via GUI
No reset
No issues after 30 minutes
My R7800 lost the 5 GHz signal then it came back on its own after about 5 minutes with no further issues. I did not have it set up to log so I do not know what happened. No issues since then. _________________ 2 R7800's (Kong OpenWRT 23.05) as access points
X86_64 build PC (DDWRT Build r55630)
3 R7000's (DDWRT build r53843)using one as a bridge currently
Netgear WNDR 3400 (DDWRT r55630)
Netgear DGND 3700 (with OpenWRT)
Joined: 16 Nov 2015 Posts: 6446 Location: UK, London, just across the river..
Posted: Sat Jan 02, 2021 20:53 Post subject:
Router Model TP-Link WR1043ND V2
Firmware Version DD-WRT v3.0-r45229 std (01/01/21)
Kernel Version Linux 3.18.140-d5 #101762 Fri Jan 1 05:52:08 +07 2021 mips
update: CLI
reset: NO
status: Operational 12h+
errors: Nothing for my set up, so far.... _________________ Atheros
TP-Link WR740Nv1 ---DD-WRT 55630 WAP
TP-Link WR1043NDv2 -DD-WRT 55723 Gateway/DoT,Forced DNS,Ad-Block,Firewall,x4VLAN,VPN
TP-Link WR1043NDv2 -Gargoyle OS 1.15.x AP,DNS,QoS,Quotas
Qualcomm-Atheros
Netgear XR500 --DD-WRT 55779 Gateway/DoH,Forced DNS,AP Isolation,4VLAN,Ad-Block,Firewall,Vanilla
Netgear R7800 --DD-WRT 55819 Gateway/DoT,AD-Block,Forced DNS,AP&Net Isolation,x3VLAN,Firewall,Vanilla
Netgear R9000 --DD-WRT 55779 Gateway/DoT,AD-Block,AP Isolation,Firewall,Forced DNS,x2VLAN,Vanilla
Broadcom
Netgear R7000 --DD-WRT 55460 Gateway/SmartDNS/DoH,AD-Block,Firewall,Forced DNS,x3VLAN,VPN
NOT USING 5Ghz ANYWHERE
------------------------------------------------------
Stubby DNS over TLS I DNSCrypt v2 by mac913