[bade-wanne007]

[edit: 07.March 2021]:
Router Model: Ubiquiti NanoStation M5
Firmware Version: DD-WRT v3.0-r45863 std (02/28/21)
Kernel Version: Linux 3.18.140-d5 #108144 Sun Feb 28 02:03:01 +07 2021 mips
[/edit]

Hello,

I would need you help in configuring my dd-wrt in such a way that the current connection stay's stable with the AP.

Application:
I would like to connect with the router to an eduroam network close by.
Therefore I set-up the 5Ghz network in the attached Wireless Client mode

Issue:
The router connects & gets a connection for a short periode - but after a few seconds (below 3 min) the connection is lossed & a re-connection will be performed.

I tried several thing to build up the connection in a stable way - but I struggle.

Therefore I uploaded the screenshots of Wireless Mode-Client configuration incl. the advanced settings & also the information of the AP situation.

The wireless security page is also attached where I hidded my personal information.

Can someone support & help me to get a stable connection ?

[kernel-panic69]

Do you have authorized legal access to this AP? We do not support helping people steal internet usage.

[bade-wanne007]

Sure I have - not steeling the "internet".

[egc]

It helps if you state router model and build number

To get the best out of DDWRT and the forum read the forum guidelines with helpful pointers:
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=324087

Your wireless settings do not seem optimal.

Consult the Wiki.

Try to use AC/N instead of mixed, and use 20 MHz channel width.

[kernel-panic69]

When you figure out why you're getting disconnected, the solution will be easy.

[bade-wanne007]

Sorry to miss some information in the inital post:

Router Model: Ubiquiti NanoStation M5
Firmware Version: DD-WRT v3.0-r45863 std (02/28/21)
Kernel Version: Linux 3.18.140-d5 #108144 Sun Feb 28 02:03:01 +07 2021 mips

Problem:
I think I do not meet the right configuration for the 5Ghz "client mode".

I adjusted the following values in the "wireless settings":
Changed Wireless Mode to : N-Only
Channel width to : 20Mhz

But as I'm not an expert in the the "wifi advanced settings", I'm still struggling with the settings.
Tried to "play" with the following values:
- Threshold - increased to 1250
- Beacon Interval - increased to 577
- DTIM Interval - increased to 2
- Sensitivity Range (ACK Timing) - set to 0

When I'm connected I archieve the following values:
Signal : -56
Noise : -95
SNR : 40

In the syslog I receive not a lot of information, which I can use for further analysis: